COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

CONTACT US FOR MORE INFORMATION ! f ` �f� n 1555 Copperhill Parkway / Santa Rosa , CA 95403 Ph : ( 800 ) 688-3375 or ( 707 ) 523-2050 �r less www . wesfernfg . com 11 ) . Insert pipe onto termination and inside swage sleeve . Must be in at least 1 1 /2 " or until just visible through holes in swage sleeve . 12 ) . Hand pump or push button to draw swage mandrel through pipe termination . FEB ' `' 2019 13 ) . Release pump pressure and remove fitting . 14 ) . When installing swage fittings , hand -tighten the coupling onto the Western Fiberglass fitting until snug . Using a Co - Flex wrench , tighten the coupling nut 1/4 turn more or to 200 in / lbs . without allowing the pipe to rotate while tightening . CAUTION : Do not over tighten . This may result in damage to the coupling or potential leaks in the system . CAUTION : Do not allow sealant to contact the threads of the swage fitting . 15 ) . Remove the protective cap from the coax pipe coupling and verify that the o -ring seals are clean and properly seated in their o - ring grooves . Remove the plastic protective cap from the coax adapter, fitting or connector and inspect the inside sealing surface to make sure it is smooth , undamaged and free of dirt . Position the coax coupling to the male threaded port of the coax fitting . This connection seals by way of static o - ring seals and does not require pipe sealant . Thread the coax swivel nut onto the male threaded port by hand , until the coupling bottoms out onto the fitting and stop . DO NOT TIGHTEN THE NUT . CAUTION : Do not use sealant inside coax couplings or on the connection threads . This may result in a gasket failure . PLEASE NOTE : Use only Dow Corning 55 O - Ring Lubricant or equivalent when cleaning or replacing coax o - rings . 16 ) . The 3/ " and 1 " Co - Flex pipe couplings are fixed male NPT fittings and are assembled as rigid steel pipe . After installing the appropriate test boot , apply a liberal amount of thread sealant or Teflon tape to the threads of the coupling and tighten to 20 ft / lbs . 17 ) . The jacket of double wall Co - Flex piping must be tested to ensure liquid tightness . Connect all test and connector tubes into the test boot or coax fittings . Tighten all band clamps to 30 in / lbs . For coax fittings , use only COPYRIGHT 2006 BY WESTERN FIBERGLASS , INC . ALL RIGHTS RESERVED . USE BY WRITTEN PERMISSION ONLY , Page 9 of 12