Laserfiche WebLink
STEP8 (COMPLETE ❑ <br /> BEAD EPDXY <br /> HEAVILY ON ALL SEAMS <br /> �Q <br /> 3600 DEGREES AROUND <br /> FITTING BEFORE <br /> CLEANUP <br /> Q <br /> c <br /> PIPE CLAMP <br /> SEAL YOUR FITTING <br /> BODY TOGETHER. <br /> n � P <br /> Stick this assembly to the wall and apply a strong pressure to push the halves <br /> together and against the wall. Epoxy should ooze from every seam and joint. Clean the <br /> face of the fitting with acetone or equivalent and remove excess epoxy. You want the fit- <br /> ting clean enough to remove the pipe clamp after the fitting cures. <br /> Use provided pipe clamp to secure the fitting halves to each other. More epoxy may <br /> ooze from the split seams as you tighten, re-clean as necessary. <br /> LET THE FITTING CURE DO NOT ALLOW THE PIPE OR <br /> CONDUITS TO MOVE OR TWIST DURING THE CURE STAGE <br /> After a full cure, remove the pipe clamp holding the two fitting halves together. If it is <br /> too difficult to remove and appears to be bonded in place, do not force it off. <br /> STEP 9 Water Testing: COMPLETE ❑ <br /> After the F-Series Retrofit-S Fittings are installed and have fully cured, water level test to a <br /> minimum of 2" above the highest penetration fitting on the sump. Follow local regulations. <br /> If this Retrofit was installed to steel sumps: <br /> Re-coat and corrosion-protect any exposed steel around the fitting area. <br /> 13 ii-F-Series-Retrofit-S-15A <br />