Laserfiche WebLink
FLX=SERIES INSTALL MANUAL <br /> FLX-SERIES IS FOR MATURE EXISTING PIPE ONLY, NOT FOR RE-PIPING. <br /> REFER TO "FLEX PIPE I.D. CHART" FOR ADHESIVES AT SBRAVO.COM/FLX <br /> 1) Remove interior boot components and remove or push bolts back into the backfill. <br /> 2) Thoroughly clean the pipe of any/all contaminants or sealants and lightly sand the exterior, 360° around. <br /> 3) Clean the wall of any/all contaminants or sealants and abrade the wall thoroughly. <br /> 4) Ensure the sump interior, pipe and fitting area will be completely dry <br /> ^ � during all installation steps. <br /> d`J <br /> 5) Hand sand the interior surface of both sleeve halves for maximum <br /> bonding grip. <br /> 6) Apply the appropriate adhesive generously to the interior of each <br /> fiberglass sleeve. <br /> 7) Clamshell both halves of the fiberglass sleeve around your pipe FIRMLY and clamp in place. <br /> APPLY CLAMP <br /> I <br /> 1 <br /> T.T <br /> U <br /> 8) Clean up excess adhesive that should have oozed from the clamshell and allow a full cure time. <br /> 9)After a full cure at the correct temperature range, remove the pipe clamps. <br /> 10) Abrade the entire exterior surface of the fiberglass sleeve, 360° around. Dust off all parts. <br /> 11) Install Retrofit-S fitting per it's installation manual, to both the wall and fiberglass sleeve. <br /> ii-FLX-RETROFIT-14B <br /> l'� BNVO W .SBRAVo.CoM made vMENC 1) / <br /> cl <br /> • PROBLEMSOLVEO 800-AT-BRAVO •v' ►C1 USA MEMBER <br />