INSTALL 1994 PIPING - Laserfiche WebLink

Home Browse Search

THE XLP. . .EXTENDED PERFORMANCE LIE IN MECHANICAL LEAK DETECTION As early as 1959, Red Jacket developed and marketed The piston version,the XLP, is constructed in design and a mechanical leak detector as a solution to the problem of materials to appreciably extend the time that it maintains leakage in the pressurized piping between the petroleum the required leak detecting capability. C product storage tanks and the dispensers. The materials used in the XLP are compatible with 100% Evolution of the Red Jacket mechanical leak detector methanol or ethanol, 100%gasoline or diesel or any com- has been ongoing for the last 30 years in response to bination of these and MTBE content up to 15%. industry demands with the original leak detector in 1959, The XLP maintains the capability of compensating for followed by the two-second diaphragm leak detector in product(thermal)contraction and is easily installed in older 1976 and the piston leak detector in 1986. or competitive model pumps with the use of the Red Jacket The evolution continues. Our research and experience leak detector housing. A tamper-proof feature is provided has enabled us to further enhance the reliability of the to prevent unauthorized alteration or removal. mechanical leak detector with the introduction of the Ex- tended Life series. Introducing the XLP... c �sSFI 1 RED JACKET CONTINUES ADVANCING MECHANICAL LINE LEAK DETECTION TECHNOLOGY • Can be installed with competitive model submersible pumps with the use of the Red Jacket leak detector housing. Can be installed in any position. • Not sensitive to vibration. • Compensates for product contraction. Tamper proof feature (accomodates wire seal) prevents • Restricted flow rate of approximately 3 GPM down- unauthorized alteration or removal. stream of the leak detector provides an easily distin- Rugged cast iron construction. guishable signal. UL Listed with approved housing. • Performs a complete line test in approximately two Designed for use with 1/3, 3/4 and 1-1/2 horsepower seconds. pumps with flows up to 70 GPM. • Easily installed in current leak detector opening on Red Jacket submersible pump. * Certain installation and operating conditions (ie.thermal contraction, foreign materials in product being pumped, unused stubs in discharge line, static head, etc.)can adversely affect the performance of mechanical leak detectors. Please refer to the Red Jacket Mechanical Leak Detector Manuals#041-978 or#5191 for a complete listing of these conditions and.proper.installation procedures. For additional information,contact the Petroleum Products Division at 1-800-HOT-PUMP (468 7867)