Laserfiche WebLink
San Joaquin County DIRECTOR <br /> Donna Heran, REHS <br /> oP Environmental Health Department <br /> �..•_��•••p ASSISTANT DIRECTOR <br /> 600 East Main Street Laurie Cotulla, REHS <br /> Q: a <br /> W :{ Stockton, California 95202-3029 PROGRAM COORDINATORS <br /> • <br /> Mike Huggins,REHS, RDI <br /> Margaret Lagorio, REHS <br /> c ��P Website: www.sjgov.org/ehd Robert McClellon,REHS <br /> 44-jFOR <br /> Phone: (209) 468-3420 Jeff Carruesco,REHS, RDI <br /> Fax: (209) 464-0138 Kasey Foley, REHS <br /> May 29, 2009 <br /> Marty Weithman <br /> Service Station Systems, Inc. <br /> 680 Quinn Ave <br /> San Jose CA 95112 <br /> Fax # (408) 213-6026 <br /> RE: USA Gas Station#68153 2448 W. Kettleman Ln. Lodi CA 95240 (SR0057415) <br /> The San Joaquin County Environmental Health Department (EHD) has completed the <br /> review of the application for permit to install a VMI 99-LD2000 Mechanical Leak <br /> Detector on the 89 product tank at the above noted address. This MLLD has already been <br /> installed and tested to pass in the presence of the inspector. The permit has been approved <br /> with the following conditions: <br /> 1. Contact the local fire department and the San Joaquin Valley Air Pollution <br /> Control District for any applicable permits and requirements. <br /> 2. Qualified service technicians must possess or work under the direct and personal <br /> supervision of an individual physically present at the work site who possesses all <br /> of the following: <br /> a. One of several permissible valid, current contractor's licenses issued by <br /> the Contractors State License Board (may be issued to the installation <br /> company), and <br /> b. A valid, current California UST Service Technician certificate issued by <br /> the International Code Council (ICC), and <br /> c. A valid, current certificate of training from the manufacturer(s) of the <br /> component(s) being tested, repaired, or serviced, and <br /> d. Each person installing or testing any component must hold a certificate of <br /> training from the manufacturer of that component. <br /> 3. Permit expires 180 days from date of approval. Note: If an extension to the <br /> expiration date is required, a written request must be submitted to this office prior <br /> to the expiration date. <br /> 4. All components must be certified by an independent testing organization and <br /> labeled as required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See <br /> California Code of Regulations (CCR), Title 23 Chapter 16 Table B for complete <br /> list). The component must bear the appropriate mark as required by the <br /> independent testing organization. <br /> Page 1 of 2 <br />