ARCHIVED REPORTS XR0008992 - Laserfiche WebLink

Home Browse Search

CM19 KEY TO ABBREVIATIONS and METHOD RSFER$NCS3 < Less than, When appearing in results column indicates analyte not detected at the value following This datum supercedes the listed Reporting Limit * Reporting Limits are a function of the dilution factor for any given sample Actual reporting limits and results have been multiplied by ' the listed dilution factor Do not multiply the reporting limits or reported values by the dilution factor dw Result expressed as dry weight mean Average, sum of measurements divided by number of measurements mg/Kg (ppm) Concentration in units of milligrams of analyte per kilogram of sample, wet-weight basis (parts per million) mg/L Concentration in units of milligrams of analyte per liter of sample ' mL/L/hr Milliliters per liter per hour MPN/100 mL Most probable number of bacteria per one hundred milliliters of sample ' N/A Not applicable NA Not analyzed ND Not detected, the analyte concentration is less than the applicable Listed reporting limit NTU Nephelometric turbidity units RPD Relative percent difference, 100 [Value 1 - Value 23 /mean value ' SNA Standard not available ug/Kg (ppb) Concentration in units of micrograms of analyte per kilogram of sample, wet-weight basis (parts per billion) ug/L Concentration in units of micrograms of analyte per liter of sample. umhos/cm Micromhos per centimeter Method References Methods 100 through 493 see "Methods for Chemical Analysis of Water & Wastes", U.S EPA, 600/4-79-020, Rev 1983 Methods 601 through 625• see "Guidelines Establishing Test Procedures for the Analysis of Pollutants" U S EPA, 40 CFR, Part 136, Rev. 1988. Methods 1000 through 9999- see "Test Methods for Evaluating Solid Waste", U.S. EPA SW-846, 3rd edition, 1986. , Rev 1, December 1987 SM- see "Standard Methods for the Examination of Water & Wastewater, 17th Edition, APRA, 1989. Revised September, 1993 abb.93 I