Laserfiche WebLink
Distillates(petroleum),hydrotreated light CAS <br /> 64742-47-8 <br /> Version 1.1 <br /> Effective Date 01.08.2012 <br /> Regulation 1907/2006/EC <br /> Safety Data Sheet <br /> safety footwear should be worn and proper handling equipment <br /> should be used. The vapour is heavier than air, spreads along <br /> the ground and distant ignition is possible. Earth all equipment. <br /> Electrostatic charges may be generated during handling. <br /> Electrostatic discharge may cause fire. <br /> 7.2 Conditions for safe Drum and small container storage: Drums should be stacked to <br /> storage, including any a maximum of 3 high. Use properly labelled and closeable <br /> incompatibilities containers. Take suitable precautions when opening sealed <br /> containers, as pressure can build up during storage. Tank <br /> storage:Tanks must be specifically designed for use with this <br /> product. Bulk storage tanks should be diked (bunded). Locate <br /> tanks away from heat and other sources of ignition. The vapour <br /> is heavier than air. Beware of accumulation in pits and confined <br /> spaces. Vapours from tanks should not be released to <br /> atmosphere. Breathing losses during storage should be <br /> controlled by a suitable vapour treatment system. <br /> 7.3 Specific end use(s) Please refer to Ch16 and/or the annexes for the registered <br /> uses under REACH. <br /> Additional Information Ensure that all local regulations regarding handling and storage <br /> facilities are followed. <br /> Product Transfer Avoid splash filling.Wait 2 minutes after tank filling (for tanks <br /> such as those on road tanker vehicles) before opening hatches <br /> or manholes. Wait 30 minutes after tank filling (for large <br /> storage tanks) before opening hatches or manholes. Keep <br /> containers closed when not in use. Do not use compressed air <br /> for filling, discharging or handling. <br /> Recommended Materials For containers, or container linings use carbon steel and low <br /> alloy steel. Aluminium may also be used for applications <br /> where it does not present an unnecessary fire hazard. For <br /> container linings the following may also be used: Unplastisized <br /> polyvinyl chloride(U-PVC), Fluoropolymers(PTFE), <br /> Polyvinyl idenefluoride(PVDF), Polyetheretherketone(PEEK), <br /> Polyamide(PA-11). For seals and gaskets use: <br /> Fluoroelastomer(FKM), Viton A, and Viton B, Nitrile butadiene <br /> (NBR), Buna-N. For coating (paint) materials use: High build, <br /> amine adduct-cured epoxy. <br /> Unsuitable Materials For containers or container linings, examples of materials to <br /> avoid are: Polyethylene (PE, HDPE), Polypropylene (PP), <br /> Polymethyl methacrylate (PMMA),Acrylonnitrile butadiene <br /> styrene(ABS). For seals and gaskets, examples of materials to <br /> avoid are: Natural rubber(NR), Ethylene Propylene(EPDM, <br /> Polychloroprene(CR)- Neoprene, Butyl (IIR), <br /> Chlorosulphonated polyethylene(CSM), e.g. Hypalon. <br /> Container Advice Containers, even those that have been emptied, can contain <br /> 8/46 <br /> Print Date 01.08.2012 000000023553 <br /> MSDS_NL <br />