Laserfiche WebLink
D. Results of Testing/Servicing .E T Dispatch <br /> Software Version Installed: ` <br /> Complete the following checklist: <br /> al'Yes CI No* Is the audible alarm o erational? <br /> U'Yes ❑ No* Is the visual alarm operational? <br /> u Yes 2-No* Were all sensors visually inspected,functionally tested, and confirmed operational? <br /> ❑'Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> (fir N/A operational.' <br /> 2'Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If ves: which sensors initiate <br /> positive shut-down? (Check all that apply) O-Sump/Trench Sensors; 2Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br /> M'Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and operatingproperly? If so,at what percent of tank capacity does the alarm trigger? % <br /> 92'Yes* ❑ No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E.below. <br /> ❑ Yes* Ir No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply)❑ <br /> Product; ❑ Water. If yes,describe causes in Section E,below. <br /> C-Yes ❑ No* Was monitorings stem set-up reviewed to ensure proper settings?Attach set up reports, if applicable <br /> ®'Yes ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? <br /> In Section IE below.describe how and when these deficiencies were or will be corrected. <br /> E. Comments: 0"1 ),v f C, <br /> l\en�dCe � �1 � C�ri ti.7d/ `�G- � wi 1'b'l 32. 3 `mac='�SOr ' <br /> Page 2 of 3 <br />