Laserfiche WebLink
801 <br /> Product Bulletin <br /> Preparation <br /> Surface is to be free of all contaminants that Cartridges <br /> would act as a bond breaker. The area to be Applications made from cartridges should <br /> sealed should be sound to the degree that not be do ed until thea application area d <br /> good bonding of the sealer will result when filled as needed until <br /> the cartridge is empty. <br /> is <br /> properly applied. The area should be dry. Stopping in the middle of and application <br /> can allow the product to set in the static <br /> Application mixer. Do not stop longer then 45 seconds. <br /> Purge the mixer of product before starting <br /> The product is mixed and applied via a 1:1 the application again. <br /> duplex cartridge or a plural component 1:1 <br /> ratio pump. <br /> The static mixer end is cut to a large "Test-Run" Like many unique products - it <br /> opening to allow for maximum flow of the takes time to effectively learn how to use a <br /> product out of the mixing tube. product. It is suggested that a user test the <br /> product and application, i.e., do a "dry run' <br /> The product is pumped out and spread over before actually making an application on a <br /> the void or crack, worked into the void. As job. <br /> the product exits the mixer is will sag <br /> slightly. As a heavy bead of product is <br /> applied next to and over the crack area it <br /> must be spread slightly moving it into place <br /> where it is needed. <br /> Place the end on the static mixer directly on <br /> the surface where the product will be <br /> applied. Pump slowly while slowly and <br /> evenly moving the product bead over the <br /> application area. <br /> Follow with a putty knife or brush immedi- <br /> ately. <br />