INSTALL 2003 - Laserfiche WebLink

Home Browse Search

Penatron 4036 + ,` k Product Bulletin P I Duplex Cartridge Priming 4036 is supplied in 21 ounce cartridges. Penatron 4036 is self-priming on most Each duplex cartridge has two parts, one substrates. In contact with steel or alumi- part A and B each. The product is num use M1312-217 or Penprime 1 before dispensed using a dual plunger manual using 4036. Test for bonding as needed. caulking gun. The gun pumps both the A & Clean-up B parts at the same time and forces the product to self-mix as it travels through the Clean any product from unwanted areas as supplied static mixer. A flow restricter is soon as it is not sticky. installed between the cartridge and the static product Storage mixer prior to attaching the static mixer to the end of the cartridge. It is important to Product may be stored at room temperature even the plungers (purge a small amount of in unopened containers. Keep product product) before installing the static mixer. warm before use. Do not store above 85 Application: Shake the cartridge before us- degrees F. or in direct sunlight and protect ing' pigment r can settle. To dispense the mately 12 months. Opened cartridge kits from extreme cold. Shelf life is approxi- product from the cartridges in gun, pump must be resealed with black plugs and used the handle quickly for the fust few strokes. within several days. The product that fust exits the end of the static mixer will not be fully mixed. Discard this small amount or direct it to a disposable Disposal cup. After discarding the first two pumps of product go directly into the application. It is Kit containers must be empty and drip free, important to apply pressure evenly and consult local, state and federal disposal laws pump the gun handle only in half strokes in before disposal. a slow and even motion. Very rapid strokes Safety on the handle can cause pour mixing. Temperature User to wear safety goggles or glasses and gloves when using this product. The product mixes best at 7 5° For higher. Read all product MSDS and make sure that Cold product may not mix well through the personnel using the products understand the static mixer and could be difficult to dis- pense. data in e MSDS and General Safety thenCartridges/products that are warmer the Sheets. Call ASTC for ques- tions concerning product use and safety. Moisture Penatron 4036 is sensitive to moisture before the two parts (A & B) are mixed, after they are mixed and until the product sets. Avoid wet conditions. If the pavement is damp and the repair must be made use MB-12-2F primer before making the appli- cation of 4036. Penprime 1 single compo- nent primer is a good choice for dry or slightly damp substrate and will bond to most anything. 3