COMPLIANCE INFO 2012 - 2018 - Laserfiche WebLink

Home Browse Search

AL(A- NE APR 2 3 2015 -2- NVIRONMENTAi. intervals, applicable to the CNI Manufacturing Phase I Vapor Recovery System as installed K&'7— GDF. n &'7—GDF. Exhibit 3 contains the manufacturing specifications. IT IS FURTHER ORDERED that compliance with the applicable certification requirements, rules and regulations of the Division of Measurement Standards of the Department of Food and Agriculture, the Office of the State Fire Marshal of the Department of Forestry and Fire Protection, the Division of Occupational Safety and Health of the Department of Industrial Relations, and the Division of Water Quality of the State Water Resources Control Board are made conditions of this certification. IT IS FURTHER ORDERED that CNI Manufacturing shall provide a warranty for the vapor recovery system and components to the initial purchaser. The warranty shall be passed on to each subsequent purchaser within the warranty period. The manufacturer of components listed in Exhibit 1 not manufactured by CNI Manufacturing shall provide a warranty to each of their components certified herein. The warranty shall include the ongoing compliance with all applicable performance standards and specifications, and shall comply with all warranty requirements in section 16.5 of the Certification Procedure. CNI Manufacturing or other manufacturers may specify that the warranty is contingent upon the use of trained installers. IT IS FURTHER ORDERED that each certified component manufactured by CNI Manufacturing, Husky, and EMCO Wheaton shall be performance tested by the manufacturer as provided in Exhibit 3. IT IS FURTHER ORDERED that the certified CNI Manufacturing System shall be installed, operated, and maintained in accordance with the ARB -Approved Installation, Operation and Maintenance Manual for the CNI Manufacturing Phase I Vapor Recovery System as certified by Executive Order VR -104-C. A copy of this Executive Order and manual shall be maintained at each GDF where a certified CNI Manufacturing System is installed. IT IS FURTHER ORDERED that all equipment listed in Exhibit 1, unless exempted in writing by the Executive Officer or Executive Officer delegate, shall be clearly identified with a permanent identification showing the manufacturer's name and model number. IT IS FURTHER ORDERED that any alteration in the equipment parts, design, installation or operation of the system certified hereby is prohibited and deemed inconsistent with this certification unless the alteration has been submitted in writing and approved in writing by the Executive Officer or Executive Officer's delegate. IT IS FURTHER ORDERED that the following requirements be made a condition of certification. The owner or operator of the CNI Manufacturing System shall conduct, and pass, the following tests no later than 60 days after startup and at least once every three (3) years after startup testing, using the following test procedures: TP -201.3, Determination of 2Inch WC Static Pressure Performance of Vapor Recovery Systems of Dispensing Facilities (March 17, 1999), TP -201.1113, Static Torque of Rotatable Phase I Adaptors (October 8, 2003), and depending on the system configuration, either TP-201AC, Leak Rate of Drop Tube/Drain Valve Assembly (October 8, 2003) or TP -201.1 D, Leak Rate of Drop Tube Overfill Prevention Devices and Spill Container Drain Valves (October 8, 2003). Shorter time periods may be CNI Manufacturing Phase I Vapor Recovery System - VR -1 04-C