Laserfiche WebLink
� � MW _ a <br /> a x <br /> 4 <br /> r—, Site Safety Plan <br /> ARCO Station No. 760, Udi, California. December 17, 1990 <br /> AGS 38048-55 <br /> 2• Examine face piece plastic center shell for cracks, missing components, or <br /> damaged threads. <br /> 3. Examine harness for breaks, cuts, frays, tears, and missing or damaged <br /> hardware. <br /> 4. Examine inhalatio^and exhalation valves and valve seats for cuts, cracks, or <br /> foreign matter which may not allow the valve to close completely. Check that <br /> valves are properly instaIIed and are no; distorted. <br /> S. Examine cartridges for signs of abuse or damage. Discard damaged items. <br /> 6. Any respirator malfunction or deficiencies noted must be reported to the <br /> +� Health and Safety Coordinator or Branch Safety Officer who will issue a new <br /> respirator or correct the deficiencies using only approved spare parts from the <br /> manufacturer of the specific model in need of repair. Spare parts from any <br /> other manufacturer may not be used under any conditiotis. Instructions in the <br /> maniw?l provided by the manufacturer should be followed when the respirator <br /> needs repairing or replacing. <br /> B. Cleaning <br /> 1. Unthread cartridges or filters. <br /> 2• Wash the face piece after use, with warm water and a mild detergent. <br /> 3. Disinfect the face piece if it was used by another person. The mask should <br /> routinely (once per month) be disinfected even if respirator is used solely by <br /> one individual. A hypochlorite solution may be used (Le, 2 tablespoons <br /> chlorine bleach per gallon of water for an acceptable solution). <br /> 4. After cleaning and air-drying, check that the face piece is not damaged and <br /> that components removed prior to cleaning have been installed properly- <br /> C. .Storage <br /> 1. Flace the respirator in its storage box in a heat- sealed or resealable plastic <br /> bag. Store flat, with the face piece and exhalation valve in an approximately <br /> normal position, to prevent the face seal from taking ,t. permanent "set." <br /> 2. Replacement components should be stored in sealed packages in a cool, <br /> clean, Iow-humidity location until ready for use. <br /> 11 <br /> A)7P11e0IGeoSy�terr�� <br />