Laserfiche WebLink
�y.u'`..,aK a+., ,�-� �' �. ^. g�'�,v .�..w.w�:. ��' � � v�.x.e�n.' i `R: .��' "� � ^`.. +•�,a"�'�6�33' � .1 _u,.. <br /> 'i <br /> •5 <br /> FQualitativefit <br /> September 15, 1989 <br /> o. 760, Lodi California AGS 38048-2S <br /> m <br /> irator Fit Test <br /> ting of each respirator must be conducted before the respirator may be <br /> used to check that a good fit is still obtained. The following steps should be taken in <br /> qualitative Cit test of the respirator. <br /> 1. Don the face piece with cartridge or filters in place. Pull straps together and <br /> equally to avoid distorting the mask. <br /> 2. Adjust the ft,ce piece. Do not overtighten it. <br /> 3. Negative Pressure Leak Check: Close off both inlet connections with palms <br /> of hands, inhale slowly, and hold breath momentarily. No leakage should be <br /> detected and the face piece should be drawn slightly to the face. <br /> 4. Positive Pressure Leak Check: Close opening in the exhalation valve guard <br /> by placing palm of one hand over face of guard; exhale slowly maintaining <br /> slight positive pressure. No leakage should be detected between the face seal <br /> and the face. <br /> 5. Should any leakage be noted: <br /> a) Adjust the headstraps and face piece slightly; recheck for leakage. <br /> b) Check condition of exhalation valve and seat. Check that both inlet <br /> gaskets are present and in proper condition. <br /> C) In the event the face piece cannot be adjusted so there is no leakage, <br /> DO NOT ENTER THE AREA REQUIRING PROTECTION. Due <br /> to your particular facial features, a different style or size face piece <br /> may be required to obtain a proper facial fit. <br /> Note: Failure to perform a qualitative fit test of the respirator each time the <br /> respirator is donned may result in little or no respiratory protection. <br /> Inspection, Cleaning,and Storage <br /> The respirator should be inspected, cleaned, and properly stored after use each day. The <br /> following steps are the basic elements of each procedure: <br /> A. Inspection <br /> 1. Examine face seal for rips. tears, holes, deformation, or stiffness. <br /> 10 <br /> y .Top/ted �eoSystems <br /> MIMMIN <br />