Laserfiche WebLink
HURRICANE <br /> Section 8. Exposure controls/personal protection <br /> Alcohols,C9-11,ethoxylated I None. <br /> Appropriate engineering Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or <br /> controls other engineering controls to keep worker exposure to airborne contaminants below any <br /> recommended or statutory limits. <br /> Environmental exposure Emissions from ventilation or work process equipment should be checked to ensure <br /> controls they comply with the requirements of environmental protection legislation. <br /> Individual protection measures <br /> Hygiene measures Wash hands, forearms and face thoroughly after handling chemical products, before <br /> eating, smoking and using the lavatory and at the end of the working period. <br /> Appropriate techniques should be used to remove potentially contaminated clothing. <br /> Wash contaminated clothing before reusing. Ensure that eyewash stations and safety <br /> showers are close to the workstation location. <br /> Eye/face protection Safety eyewear complying with an approved standard should be used when a risk <br /> assessment indicates this is necessary to avoid exposure to liquid splashes, mists, <br /> gases or dusts. If contact is possible, the following protection should be worn, unless <br /> the assessment indicates a higher degree of protection: chemical splash goggles and/ <br /> or face shield. If inhalation hazards exist, a full-face respirator may be required instead. <br /> Skin protection <br /> Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be <br /> worn at all times when handling chemical products if a risk assessment indicates this is <br /> necessary. Considering the parameters specified by the glove manufacturer, check <br /> during use that the gloves are still retaining their protective properties. It should be <br /> noted that the time to breakthrough for any glove material may be different for different <br /> glove manufacturers. In the case of mixtures, consisting of several substances, the <br /> protection time of the gloves cannot be accurately estimated. <br /> Body protection Personal protective equipment for the body should be selected based on the task being <br /> performed and the risks involved and should be approved by a specialist before <br /> handling this product. <br /> Other skin protection Appropriate footwear and any additional skin protection measures should be selected <br /> based on the task being performed and the risks involved and should be approved by a <br /> specialist before handling this product. <br /> Respiratory protection Based on the hazard and potential for exposure, select a respirator that meets the <br /> appropriate standard or certification. Respirators must be used according to a <br /> respiratory protection program to ensure proper fitting, training, and other important <br /> aspects of use. <br /> Section 9. Physical and chemical properties <br /> Appearance <br /> Physical state Liquid. <br /> Color Tan. <br /> Odor Acidic. <br /> Odor threshold Not available. <br /> pH 1 to 2 [Conc. (%w/w): 100%] <br /> Melting point Not available. <br /> Boiling point 93.3°C (199.9°F) <br /> Flash point Not available. <br /> Evaporation rate Not available. <br /> Flammability (solid, gas) Not available. <br /> Tel :+1-888-GHS-7769(447-7769)/+1-450-GHS-7767(447-7767) 6112 <br /> to KMK Regulatory Services www.kmkregservices.com www.askdrluc.com www.ghssmart.com <br />