Laserfiche WebLink
� 5 <br /> e. q� <br /> 'h <br /> vo M� <br /> Y <br /> sampling, latex gloves will be wort: to prevsnt cross <br /> contamination <br /> be dedic ted to eachssample collect d.disposable <br /> - one pair of <br /> gloves wf <br /> Once the sample is collected, each end of the cylinder will <br /> be sealed with aluminum foil or teflon tape and then capped <br /> with a polyethylene lid, taped, and labeled. The sample <br /> will then be individually sealed in a ziplock bag and <br /> .� immediately placed in an ice chest containing dry ice or <br /> frozen chemical ice for delivery to a state certified <br /> laboratory. Sample identification, storage and <br /> transportation will be .onducted as outlined in the previous <br /> section. <br /> 11.3 Sampling from Soil Piles or Shallow Soil Pits <br /> Soil samples will be collected and transported frc)xr <br /> excavated material in the manner described in the previous <br /> section, however, a backhoe will not be utilized. If <br /> composite samples are collected, four brass cylinders will <br /> be collected for every 50 cubic yards of material to be <br /> sampled unless otherwise specified by the lead regulatory <br /> d by the <br /> M <br /> agency. The samples will be composit rior to testing.state <br /> certified analytical laboratory personnel P <br /> 12.0 Groundwater Sampling Protocol <br /> sampling <br /> Prior to arriving at the sampling sfte•radeldetergent, <br /> equipment will be washed with laboratory g <br /> and rinsed trice with tap water, once with acetone, and once <br /> with deionized water. This procedure will be carrifd morte <br /> on-site before sampling of other monitoring wells, <br /> than one well is to be sampled with the same sampling <br /> "r device. <br /> immediately prior to sampling;. the depth to water (DTW) in <br /> rded. Tha thickness of product on top <br /> tije .?well will be reco <br /> of the , groundwater, if present, will be measured p <br /> interface probe. The procedure for monitoring is presented <br /> in Section 9.0 (Groundwater Monitoring Protocol). <br /> IE free product is detected, analysis of groundwater at the <br /> interface for dissolved product will not be conducted. A <br /> product sample will be collected for source identification. <br /> If all free product cannot be removed, an interval specific <br /> sampling device may be utilized to collect a sample from <br /> below the zone of free product. Before cost <br /> thecwell swill ape <br /> two groundwater samples :-from each well, <br /> purged until indicator pit l <br /> of Arameters (temperature, cor►daeast <br /> ---------- - ---and--p8 l.-stabilize. This will entail the removal <br /> - at least <br /> ------ ------ or--pumping• ----The----- <br /> well casing vo <br /> four lumes by_-..bailing- -- --- <br /> fouris for determining well casing volumes and temporary <br /> in 5ectian. O.Q, (Well <br /> storage, of purge water is outlined. <br /> Developmentobot/1 indbefore andaftercator �pu gingrof eacheasurewell <br /> will be token <br />