Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 324.01 <br />Complete the following checklist: <br />E .� ,L <br />MAR 3 0 2016 <br />ENVIRONMENTAL <br />® Yes <br />No* <br />Is the audible alarm operational? <br />® Yes <br />❑ No* <br />Is the visual alarm operational? <br />® Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their <br />proper operation? <br />Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />® N/A <br />® Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br />❑ N/A <br />detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) <br />® Sump/Trench Sensors; ® Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor <br />failure/disconnection? ® Yes; No. <br />Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention <br />N N/A <br />valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent <br />of tank capacity does the alarm trigger? % <br />Yes* <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E, below. <br />Yes* <br />®No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) Product, El Water. If <br />yes, describe causes in Section E, below. <br />® Yes <br />No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />® Yes <br />❑ No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />In Section t below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />TANK ANNULARS ARE OPTICAL SENSORS V/R 433 OPERATING AS DESIGNED. <br />BOTH PREMIUM & DIESEL TANK FILLS HAVE OPW OVERFILL VALVES INSIDE DROP TUBES. <br />Monitoring System Certification Page 2 of 4 12/07 <br />2 <br />2/21/07 <br />