Laserfiche WebLink
San-.vunty <br />oP "' Environmental Health Department <br />600 East Main Street <br />Stockton, California 95202-3029 <br />C4G/FE6 ,R Website: www.sjgov.org/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />October 22, 2008 <br />Bonnie Garber <br />Donlee Pump Company <br />2825 Railroad Ave <br />Ceres, CA 95307 <br />Fax: (209) 537-9398 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent via Fax and Mail <br />Subject: Village West Marina, 6649 Embarcadero Drive, Stockton, CA (SR0055715) <br />The San Joaquin County Environmental Health Department (EHD) has completed the review of <br />the application for permit to change the Veeder Root monitoring panel TLS 350 ECPU circuit <br />board. This repair requires a system cold start. The permit has been approved with the following <br />conditions: <br />Conditions of approval: <br />1. Contact the local fire department, local planning or building department and the San <br />Joaquin Valley Air Pollution Control District for any applicable permits. <br />2. Any changes shall be submitted to the San Joaquin County Environmental Health <br />Department (EHD) for approval prior to commencing work. All new addenda supercede <br />the previous ones. <br />3. Before the alarm history is cleared by the "cold start", a current printout must be <br />created and be available for EHD inspection. <br />4. Contact Garrett Backus (209-468-2986) to arrange the following inspection(s) (a 48-hour <br />notice is required): <br />a. The EHD must witness the testing of the functionality of the monitoring system <br />to ensure that monitoring has been restored to meet the requirements of <br />California Code of Regulations Title 23 and the Health & Safety Code. All <br />monitoring system sensors must be tested. Electronic line leak detectors must be <br />tested, if installed at this site. <br />5. A "Certification of Installation / Modification" form shall be submitted by the owner <br />or the owners' agent [pursuant to (CCR) 2635(d)] before this upgrade will be considered <br />complete by EHD. <br />6. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />7. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all of the <br />following: <br />Page 1 of 2 <br />