Laserfiche WebLink
MicroSensor Installation Guide Warnings and Important Notes <br /> Warnings and Important Notes <br /> A WARNING <br /> This product is to be installed in systems operating near locations where highly <br /> . • combustible fuels or vapors may be present. <br /> Fire or explosion resulting in serious injury or death could result if the <br /> equipment is improperly installed or modified.Serious contamination of the <br /> environment may also occur. <br /> 1. Read and follow all instructions in this manual,including all safety <br /> warnings to protect yourself and others from serious injury,explosion,or <br /> electrical shock. <br /> 2. Comply with all applicable codes including:the National Electrical Code; <br /> federal,state,and local codes;and other applicable safety codes. <br /> 3. Do not alter or modify any component or substitute components in this kit. <br /> 4. Substitution of components may impair intrinsic safety. <br /> 5. Circuitry within the sensor and console barrier form an intrinsically safe, <br /> energy-limited system.This system makes the discriminating interstitial <br /> sensor intrinsically safe for use in a Class I,Group D hazardous location. <br /> The sensor wiring is intrinsically safe only when connected to an approved <br /> Veeder-Root Console. <br /> Failure to install this product in accordance with its instructions and warnings will result in voiding of all warranties <br /> connected with this product. Do not attempt to wire a MicroSensor into a new site based solely on the information <br /> contained in this manual.This manual contains installation procedures for a MicroSensor into an existing system <br /> only! <br /> For new installations,and for wiring requirements,see the "Site Preparation and Installation Instructions" manual <br /> provided with the system. <br /> INSTALLATION COMPONENTS <br /> • MicroSensor for Fiberglass Tanks P/N 7943X0-34X <br /> • Installation Kit- P/N 312020-949 (Figure 1) <br /> • Optional 2" riser cap and adaptor kit- P/N 312020-928 <br /> • Manual 576013-285 <br /> 0 <br /> Tie wrap(2) <br /> PIN 510901-337 /Cord Grip Nut <br /> Wire nut(2) <br /> P/N 576008-461 l <br /> Bushing Note:watch orientation <br /> (fits into \ of bevels and tapers <br /> tapered when assembling these <br /> end of fitting) OEM cord grip components. <br /> Fitting Body <br /> screw <br /> into J-Box) <br /> Epoxy sealant(2) Cord Grip Fitting(2) s .�s <br /> P/N 514100-304 P/N 331028-021 <br /> Figure 1. Installation kit <br /> 3 <br />