Laserfiche WebLink
RECEIVED <br />OCT 2 7 2016 <br />T <br />Installation Hardware <br />The Sump Sensor's Installation kit is shown in Table 1: <br />Table 1.- Sump Sensor Installation Kit (PM 330020-076) <br />Item <br />Qty. <br />Description <br />Part No. <br />1 <br />2 <br />Mounting strip <br />330314-001 <br />2 <br />2 <br />#4-20 x 3/8" Plastite screw <br />510500-398 <br />3 <br />3 <br />1/4"-20 x 1/2" Bolt, hx hd <br />503328-001 <br />4 <br />3 <br />1/4"-20 Speed nut <br />511000-232 <br />5 <br />2 <br />Wire nut <br />576008-461 <br />6 <br />1 <br />Sealing pack <br />514100-304 <br />7 <br />1 <br />Cord grip <br />331028-001 <br />8 <br />2 <br />Tie wrap <br />510901-337 <br />Site Preparation <br />Check that the Sump Sensor's field wiring is not connected to the console. <br />Mounting Sensor to Support Member <br />1. Make sure no liquid exists in the sump. Failure to comply can result in undetected potential environmental and <br />health hazards. <br />2. Attach one of the mounting strips to the top of the sensor using the 2 Plastite screws provided as shown in <br />Figure 1. <br />Important! The sensor must be positioned in the lowest part of the sump and it must be mounted in a true ver- <br />tical position to ensure proper operation of the float switch contained inside. <br />3. Depending on your mounting requirements (again see Figure 1), attach the second mounting strip to the first <br />strip using two 1/4-20 x 1/2 -inch screws and speed nuts. With the sensor resting on the bottom of the sump, <br />wrap the mounting strip around the support member and secure it using a 1/4-20 x 1/2 -inch screw and speed <br />nut. <br />4. Carefully bend the mounting strip so that the sensor is in a true vertical position and still rests on the bottom of <br />the sump. <br />5. Install the cord grip into the junction box. Feed the sensor cable through the cord grip on the junction box. <br />Tighten the cord grip nut to ensure a water -tight seal at the cable entry. <br />