FIELD DOCUMENTS CASE 2 - Laserfiche WebLink

Home Browse Search

DER A-3.2 �ensmxoni�asmsw�. A-3.2 Monitoring Well Development and Sampling ' The wells are developed to reduce the effects of drilling on the formation and to increase the effective hydraulic radius of the well. Monitoring wells are generally developed 24 to 48 hours after installation to allow the ' grout to set. Each well is first sampled with a clear acrylic bailer to visually inspect for hydrocarbon layer or sheen. If no product layer or sheen is observed on the water, the ' well is developed by surging, pumping, or bailing. Surging along the screened interval of the well is performed to draw the sediment from the formation into the filter pack and the well and to set the sand pack. The sediment laden water is purged from the well at a rate of between 0.75 to 10 gallons per minute (gpm) depending on recharge rate and casing size. Development continues until the discharge runs relatively clear of fines. Approximately 5 to 10 well volumes are generally removed from each monitoring well. Discharge water is stored in 55-gallon drums and left on site for later discharge or disposal by the client, depending on laboratory results. After the wells are developed, the aquifer is allowed to equilibrate for at least 24 to 48 hours. The wells can then be purged and sampled. Purging and sampling may be accomplished with Teflon bladder pumps and/or bailers. During the purging of the wells, ' field parameters (pH, conductivity, and temperature) are monitored. Samples are collected after the field parameters have stabilized (normally requiring the removal of ' three to five well volumes). Water sampling containers are supplied and prepared by the laboratory. These sample containers are immediately sealed after sample collection ' and placed in an iced cooler. At the end of the day, the water samples are delivered under chain-of-custody to an analytical laboratory certified by the state for the planned ' chemical analysis. A-3.3 Sample Handling After labeling, the sample is immediately stored in an iced cooler for transport to the analytical laboratory. The label includes Kleinfelder's name, job number, the date and ttime the sample was collected, the employee number of the individual who performed the sampling, and a unique five-digit sample identification number. A custody seal is ' also placed on the sample in such a way that any attempt to tamper with the sample is ' 101486.4/STO12R025 Page A-5 February 1, 2012 ' Copyright 2012 Kleinfelder