Laserfiche WebLink
DER <br /> Bright Bright Ie.flight Wliiiu <br /> easily visible. An example of a sample label and custody seal are attached at the end <br /> of this appendix. <br /> A Kleinfelder chain-of-custody form is attached to the cooler. The chain-of-custody form <br /> includes Kleinfelder's name, address and telephone number, the employee number of <br /> the individual who performed the sampling, the sample numbers, the date and time the <br /> samples were collected, the number of containers each sample occupies, and the <br /> analyses for which the samples are being submitted. The chain-of-custody form is <br /> signed by each person who handles the samples, including all Kleinfelder employees <br /> and the receiving employee of the analytical laboratory when the samples are delivered. <br /> ' An example of the chain-of-custody form is attached. <br /> A-3.4 Equipment Decontamination <br /> To reduce the potential for cross-contamination between wells, all developing and <br /> ' sampling equipment is washed in a trisodium phosphate solution and rinsed in distilled <br /> water or steam cleaned prior to use in the next monitoring well. <br /> A-3.5 Well Survey <br /> ' The locations of soil borings and monitoring wells and the elevation of the top of the <br /> PVC casings is usually surveyed and tied into permanent markers, if readily available. <br /> Survey accuracy is 0.1 foot for the "x" and "y" coordinates and .01 foot for the "z" <br /> coordinate. The depth to static ground water is measured from a set location at the top <br /> of the PVC casing. The depth of water is then subtracted from the elevation of the top <br /> of the well casing to provide a ground water elevation for each monitoring well location. <br /> ' A-4. COLLECTION HYDROPUNCH Ile GROUNDWATER SAMPLES <br /> One-time groundwater samples are collected using a Hydropunch II°, which is an in situ <br /> groundwater sampling device. The borings will be advanced to a depth equivalent to the <br /> bottom of the capillary fringe. A stainless steel drive tip equipped with a filter is lowered <br /> into the borings at the end of a 2.5-inch diameter galvanized steel pipe and pushed <br /> ' using the drill rig approximately 3 to 5 feet into the soil/aquifer formation at the bottom <br /> of the boring. A thoroughly decontaminated bailer can then be lowered down the center <br /> of the Hydropunch Ile casing to obtain a sample of groundwater (which has entered the <br /> Hydropunch II° due to hydrostatic pressure). <br /> 1 <br /> 101486.5/ST012R0588 Page A-6 July 31, 2012 <br /> Copyright 2012 Kleinfelder <br />