Laserfiche WebLink
' KLEINFE L D E R <br /> A-7 SURFACE WATER MONITORING <br /> ' 1. Prior to collecting surface water samples, the depth of water is estimated at a designated <br /> ' location in the surface water body. <br /> 2. Surface water samples are collected directly from the stream or surface water using a <br /> ' clean unpreserved plastic bottle, disposable bailer, bailer, coliwasa, DipstikTM, dipper, <br /> peristaltic pump, etc., or by directly filling the sample containers. Sampling equipment <br /> ' will either be disposable, dedicated or decontaminated in accordance with the above- <br /> defined decontamination protocols. Care is taken not to disturb the stream bottom and <br /> ' introduce sediment in the sample. The fluid is then poured into appropriate preserved or <br /> unpreserved bottles for the requested analysis. <br /> ' 3. The sample is labeled and immediately stored in an iced cooler pending transport to the <br /> analytical laboratory. The sample is logged on a chain-of-custody. <br /> 1 <br /> ' A-8 TANK REMOVAL SAMPLING <br /> A-8.1 Collection of Soil Samples and Laboratory Analysis <br /> ' Soil and water samples will be collected during the tank removal operations in accordance with <br /> ' the current Leaking Underground Fuel Tank Field (LUFT) Manual and the Tri-Regional <br /> Guidelines issued by the California Regional Water Quality Control Board (RWQCB). <br /> ' A Kleinfelder, environmental geologist will be on site during the tank removal activities to <br /> collect soil samples for qualitative field screening and laboratory analysis. Tank excavation soil <br /> ' samples will be obtained by scraping the sidewalls or excavation bottom at the desired locations <br /> with the backhoe bucket. Samples will then be collected from the bucket by packing soil in a <br /> ' clean brass tube with a clean hand trowel. The soil samples may also be collected using a slide <br /> hammer lined with a clean brass tube with appropriate extension to reach the desired sampling <br /> ' depth. The collected brass tubes will then be sealed with Teflon sheets and tight fitting plastic <br /> caps. <br /> 1 <br /> 20-1111-O I.WPI/201 I P121 Page A-9 <br /> Copyright 2001,Klcinfelder,Inc. May 8,2001 <br />