Laserfiche WebLink
11/04-05/93 <br /> Burners and Controls replaced burner and pilot assembly. <br /> 11/05/93 <br /> Unit off on arrival, restart and Adjust unit after was <br /> repaired Collect bag samples of MW1, MW2/3 , MW10, Ex, <br /> influent, and effluent for WEGE laboratory. System set at <br /> 0* air dilute. <br /> 11/17/93 <br /> Unit running on arrival Adjust unit and sample . Collect bag <br /> sample of influent for WEGE laboratory. System set at 0°s Air <br /> dilute . <br /> 11/30/93 <br /> Unit running on arrival Adjust unit and sample Collect bag <br /> samples of influent and Effluent for WEGE laboratory. <br /> System set at 0% air dilute . <br /> 12/07/93 <br /> Unit running on arrival Adjust unit and sample Collect bag <br /> sample of influent for WEGE laboratory System set at 0% air <br /> dilute . <br /> 12/16/93 <br /> Unit shut down due to mechanical failure As of January 1, <br /> 1993 , the Unit had not been restarted. <br /> The VOC emissions have never exceeded the 52 lb/day emission limit <br /> for the site . No evidence of Tetrachloroethylene (PCE) was found <br /> during examination of the chromatograms of the samples taken to the <br /> WEGE laboratory. <br /> VAPOR SAMPLING <br /> COILFCTXNG LABORATORY SAMPLES <br /> Influent Sample <br /> The influent sample is obtained from a sample port located after the <br /> system vacuum pump before the REMOX Unit . Sterile poly tubing is <br /> then used to attach a 1 liter tedlar bag, fitted with a special <br /> septum "valve" and tubing bib, to the sample port The sample port <br /> is on the pressure side of the pump and therefore the bag will fill <br /> without need of a pump. Once the tedlar bag is filled, its valve is <br /> closed and locked; the appropriate label is placed on the tedlar <br /> bag. <br /> page 2 of 8603 , 01/18/94 <br />