Laserfiche WebLink
' RESTRICTED MATERIALS PERMIT#39-17-3904239 Page 6 of 7 <br /> KOOYMAN, MIKE Expires: 12/3112017 <br /> ' jX] 2. Do not discharge material more than 10 feet above the crop or target. <br /> (X] 3.A drift reducing agent shall be added to the spray mixture at label rates. <br /> ' (X] 4.Maximum wind velocity for Phenoxy herbicides-10 m.p.h. <br /> [X] S.Maximum wind velocity for Dicamba-10 m.p.h. EXCEPT when wind Is moving In direction of sensitive crops,the <br /> t maximum wind velocity-5 m.p.h. <br /> [X] S. No Dicamba or Phenoxy herbicide applications allowed beginning March 16 and continuing through October 15,and <br /> until grape leaves in the vicinity of the treated area are"browned off'. <br /> ' Revised 11115 <br /> SITE CONDITIONS <br /> B RM Use Near Schools <br /> CONDITION B REST.MAT.USE NEAR SCHOOLS <br /> ' No applications of Restricted Materials shall be made by air or ground within 1320 feet of a school in session or when a school <br /> sponsored event is in progress. if the pesticide label or regulation requires a larger buffer area,the larger buffer shall apply. <br /> There will be no waiver of the required 24 hour Notice of Intent, <br /> ' These conditions do not apply to the following ground applications: <br /> 1.Vertebrate pest control <br /> 2,Back-pack applications <br /> ' 3.Equipment where all nozzles are pointing down AND wind direction is periodically measured as moving away from the school <br /> site <br /> 4.0ther CAC approved methods <br /> ' NOTE: The uses of soil fumigants and their corresponding buffer zones are covered by DPR suggested permit conditions or <br /> by label. <br /> ' GWP-R3 Band treatment <br /> CONDITION-GWP-R3 - RUNOFF GROUNDWATER PROTECTION AREAS, BAND TREATMENT. <br /> 3CCR section 6600(a)pesticides shall be applied as a band treatment immediately adjacent to the crop row so that not more <br /> ' than 33 percent of the distance between rows is treated. <br /> P General <br /> tCONDITION-P-General <br /> In addition to all applicable taws, regulations, label restrictions and other more restrictive <br /> ' conditions of this permit,THE FOLLOWING CONDITIONS APPLY TO APPLICATIONS COVERED BY THIS PERMIT. <br /> 1, Maximum wind velocities for applications of Restricted Materials unless otherwise covered by the label,law, regulation,other <br /> ' permit conditions or environmental <br /> conditions at the application site are: <br /> a.Spray-12 m.p.h. <br /> ' b. Dust-6 m.p.h. <br /> c.Pallets,granular or baits-19 m.p.h. <br /> 1 <br />