SU0011448_SSNL - Laserfiche WebLink

Home Browse Search

• Percolation Test Two shallow percolation tests were conducted on the Site; the shallow soil borings discussed above were used for the percolation test holes (Plate 13). Percolation test procedures conformed to San Joaquin County Environmental Health Department policy. Preparation and Presaturation of Percolation Test Holes After the borings were advanced by hand auger and the soils logged, the test holes were completed for the percolation tests. Approximately 2 inches of pea gravel were placed in the bottom of each open soil boring, followed by a 1.5-inch diameter PVC pipe with perforations on the bottom. Pea gravel was then used to backfill a few inches of the annular space. Live Oak presaturated each percolation test hole approximately 24 hours prior to the percolation testing. Each hole was filled with water to a height of 12 inches above the bottom of the boring for the presaturation. On the day of testing, each percolation test hole was found to be intact and dry. Percolation Test Procedure Live Oak conducted the percolation tests for the borings on May 10, 2017. Due to initial percolation rates observed, four-hour tests were selected. Water level measurements • were taken every half-hour during this four-hour period. Ted Tasiopoulos, Senior Registered Environmental Health Specialist at the San Joaquin County Environmental Health Department, observed the last half-hour of each test. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, each hole was refilled with water to a level of six inches or more above the bottom of the hole. Percolation Test Results The completed percolation test form is included in Appendix 3 of this report. The form was signed by Mr. Tasiopoulos and indicates a percolation rate for each hole based on the final water drop observed. Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 36 and 42 inches; a satisfactory percolation rate for a shallow test is less than or equal to 60 minutes per inch (min/in) drop. For the Site to utilize a standard septic system, one percolation test must demonstrate a satisfactory percolation rate within the proposed septic system disposal field. • LOGE 1714 Page 11