Laserfiche WebLink
Height Limitations <br /> Airport Property(AP) requires an airspace review for objects over 35 feet tall.The elevation plan shows a height <br /> of 34'ft. 6 in.Any temporary or permanent object will be incorporated into the total building height. <br /> Vri,dra„ u z& <br /> Other Hazard of Flight <br /> The project applicant must strongly consider the standards and project design conditions below during the <br /> development of the project. The application states "Materials used on-site includes but not limited to the <br /> following: Boiler Water Treatment Chemicals, Water Softener (Salts), Propane, Tri-Gas (Carbon <br /> Dioxide/Argon/Helium), Acetylene, Hydraulic Oil, Sonitizers, Stainless Steel Cleaners, Glass Cleaners, Aerosols, <br /> Bleach, Deodorizers, Chlorinated Cleaners, Gear lubricant and Gasoline. Materials stored on-site includes but <br /> not limited to:Dental Amalgam, Compressor Oil, Vapo-Steril,Cold Steril,Fixer/Development, Glutaraldehyde,and <br /> Lead Foil."The storage containers of the materials used or stored can become reflective,which may create glare <br /> or distracting lights. In addition, SJCOG staff requests clarification the transfer of waste will not create smoke, <br /> dust, or steam that could impair the pilot's vision. <br /> Noise <br /> The project lies within CNEL(Community Noise Equivalent Level) 60 and SEL(Sound Exposure Level)95.SJCOG <br /> staff recommends the project-refer to 1d below. <br /> SJCOG would like to provide standards and project design conditions that comply with the Airport Land Use <br /> Compatibility Plan (https://www.sicog.org/ALUC) as a reference guide. Note: Jurisdictions determine if the <br /> following standards and conditions apply to this project. <br /> 1. Newland uses that may cause visual,electronic,or increased bird strike hazards to aircraft in flight shall <br /> not be permitted within any airport's influence area.Specific characteristics to be avoided include: <br /> a. Glare or distracting lights which could be mistaken for airport lights. Reflective materials are <br /> not permitted to be used in structures or signs(excluding traffic directing signs). <br /> b. Sources of dust,steam,or smoke which may impair pilot visibility. <br /> c. Sources of electrical interference with aircraft communications or navigation. No transmissions <br /> which would interfere with aircraft radio communications or navigational signals are permitted. <br /> d. Occupied structures must be soundproofed to reduce interior noise to 45 decibel(dB)according <br />