SU0011244 SSNL - Laserfiche WebLink

Home Browse Search

• Preparation and Presaturation of Percolation Test Holes After the borings were advanced by hand auger and the soils logged, each test hole was completed for the percolation testing. Approximately one inch of pea gravel was placed in the bottom of the open soil boring, followed by a 2.0-inch diameter PVC pipe with perforations on the bottom. Pea gravel was then used to backfill a few inches of the annular space. Live Oak presaturated each percolation test hole approximately 24 hours prior to the percolation testing. The holes were filled with water to a height of 12 inches above the bottom of the boring for the presaturation. On the day of testing, the holes were found to be intact and dry. Percolation Test Procedure Live Oak conducted the percolation tests for the borings on May 19 and 23, 2017. Due to soil conditions observed, four-hour tests were selected. Water level measurements were taken every 30 minutes during this four-hour period. The last 30 minutes of each test were observed by Michael Escotto, Senior Registered Environmental Health Specialist at the San Joaquin County Environmental Health Department. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, the hole was refilled with water to an approximate level of six inches above the bottom of the hole. Percolation Test Results The completed percolation test forms are included in Appendix 3 of this report. The forms were signed by Mr. Escotto and indicate the percolation rate for each hole based on the final water drop observed. Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 36 and 42 inches; a satisfactory percolation rate for a shallow test is less than or equal to 60 minutes per inch (min/in) drop. A deep percolation test hole has a depth greater than 3.5 up to 25 feet; a satisfactory percolation rate for a deep test is 30 min/in or less. For the Site to utilize a standard septic system, one percolation test (either a shallow or deep test) must demonstrate a satisfactory percolation rate within the proposed septic system disposal field. Details and results of the percolation testing are summarized in the following table. • LOGE 1706 Page 6