Laserfiche WebLink
Kathy Allen V%I *,d June 16,2006 <br /> PA-0600320(SA), Real Development,LLC, (APN 131-080-13) Page 2 <br /> District has approved the Dust Control Plan. A template of the District's Dust Control Plan is available at <br /> htto://www.vallevair.oro/busind/com olv/PM 10/form s/DCP-Form%20-%2012-01-2005.doc. <br /> Rule 4102 (Nuisance) This rule applies to any source operation that emits or may emit air contaminants or <br /> other materials. In the event that the project or construction of the project creates a public nuisance, it could <br /> be in violation and be subject to District enforcement action. <br /> Rule 4103 (Open Burning) This rule regulates the use of open burning and specifies the types of materials <br /> that may be open burned. Agricultural material shall not be burned when the land use is converting from <br /> agriculture to non-agricultural purposes (e.g., commercial, industrial, institutional, or residential uses). <br /> Section 5.1 of this rule prohibits the burning of trees and other vegetative (non-agricultural) material <br /> whenever the land is being developed for non-agricultural purposes. In the event that the project applicant <br /> burned or burns agricultural material, it would be in violation of Rule 4103 and be subject to District <br /> enforcement action. <br /> Rule 4601 (Architectural Coatings)This rule limits volatile organic compounds from architectural coatings by <br /> specifying architectural coatings storage, clean up and labeling requirements. <br /> Rule 4641 (Cutback, Slow Cure, and Emulsified Asphalt, Paving and Maintenance Operations) If asphalt <br /> paving will be used, then paving operations of this project will be subject to Rule 4641. This rule applies to <br /> the manufacture and use of cutback asphalt, slow cure asphalt and emulsified asphalt for paving and <br /> maintenance operations. <br /> Rule 9510 (Indirect Source Review) This rule was adopted to reduce the impacts of growth in emissions <br /> from all new development in the San Joaquin Valley. Rule 9510 requires applicants subject to the rule to <br /> provide information that enables the District to quantify construction, area and operational PM10 and NOx <br /> emissions, and potentially mitigate a portion of those emissions. An application must be filed with the District <br /> no later than concurrent with application with a local agency for the final discretionary approval. For more <br /> information and instruction, please contact the District's ISR staff by phone at (559) 230-5800 or by email at <br /> ISR(a)valleyair.ora <br /> The District encourages innovation in measures to reduce air quality impacts. There are a number of <br /> features that could be incorporated into the design/operation of this project to provide additional reductions of <br /> the overall level of emissions. (Note: Some of the measures may already exist as San Joaquin County <br /> development standards. Any measure selected should be implemented to the fullest extent possible.) The <br /> suggestions listed below should not be considered all-inclusive and remain options that the agency with the <br /> land-use authority should consider for incorporation into the project. <br /> • Large canopy trees should be carefully selected and located to protect the building(s) from energy <br /> consuming environmental conditions, and to shade 50% of paved areas within 15 years. Also, trees <br /> should be planted adjacent to all sidewalks thirty foot on center and at a ratio of one tree for each five <br /> parking spaces. Structural soil should be used under paved areas to improve tree growth. For <br /> information on Structural Soil see http://www.hort.cornell.edu/uhi/outreach/esc/. For information on Tree <br /> Selection see htto://www.ufei.org/. For Urban Forestry see htto://www.coolcommunities.org, <br /> htto://wcufre.ucdavis.edu and htto://www.lgc.org/bookstore/energy/downloads/siv tree quidelines.odf. <br /> • As many energy conserving and emission reducing features as possible should be included in the <br /> project. Energy conservation measures include both energy conservation through design and <br /> operational energy conservation. Examples include(but are not limited to): <br /> - Increased energy efficiency(above California Title 24 Requirements) <br /> See htto://www.energy.ca.gov/title24/. <br /> - Energy efficient widows (double pane and/or Low-E), lighting, appliances, and heating and cooling <br /> systems. See htp://www.energvstar..qov/ <br /> - Programmable thermostats for all heating and cooling systems <br /> - Use Low and No-VOC coatings and paints. See South Coast's site for No-VOC Coatings at <br /> http://www.aqmd.qov/i)rdas/brochures/paintguide.htmi <br />