SU0011130 SSNL - Laserfiche WebLink

Home Browse Search

• A shallow percolation test was conducted on each proposed parcel of the Site. The soil borings discussed above were used for the percolation test holes (Plate 10). (, Percolation test procedures conformed to San Joaquin County Environmental Health Department policy. Preparation and Presaturation of Percolation Test Holes After the borings were advanced by hand auger and the soils logged, the test holes were completed for the percolation tests. Approximately one inch of pea gravel was placed in the bottom of each open soil boring, followed by a 2.0-inch diameter PVC pipe with perforations on the bottom. Pea gravel was then used to backfill a few inches of the annular space. Live Oak presaturated the percolation test holes approximately 24 hours prior to the percolation testing. The holes were filled with water to a height of 12 inches above the {J bottom of the boring for the presaturation. On the day of testing, all four holes were found to be intact and dry. Percolation Test Procedure Live Oak conducted the percolation tests for the borings on April 4, 2017. Due to soil • conditions observed, four-hour tests were selected. Water level measurements were taken every 30 minutes during this four-hour period. The last half hour of each test was observed by Michael Escotto, Senior Registered Environmental Health Specialist at the San Joaquin County Environmental Health Department. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, the holes were refilled with water to a level of six inches or more above the bottom of the hole. Percolation Test Results The completed percolation test forms are included in Appendix 3 of this report. The forms were signed by Mr. Escotto and indicate the percolation rate for each hole based on the final water drop observed. Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 36 and 42 inches; a satisfactory percolation rate for a shallow test is less than or equal to 60 minutes per inch (min/in) drop. For the Site to utilize a standard septic system, one percolation test per parcel must demonstrate a satisfactory percolation rate. • Details and results of the percolation tests are summarized in the following table. LOGE 1702 Page 7