COMPLIANCE INFO PRE 2019 - Laserfiche WebLink

Home Browse Search

(f) A generator or owner or operator authorized pursuant to Permit -by -Rule pursuant to Chapter 45 of this division, Conditional Authorization pursuant to HSC 25200.3, or Conditional Exemption pursuant to HSC 25201.5, operating a non-RCRA underground tank system or an underground tank system otherwise exempt from permitting requirements pursuant to the federal act, shall comply with the applicable standards of Title 23 of the California Code of Regulations relating to underground tank systems. (g) The tank system assessment shall include all of the following information: (1) tank configuration (i.e., horizontal, vertical), and gross capacity (in gallons); (2) design standard(s), if available, according to which the tank and ancillary equipment were constructed and all of the following information; (A) material of construction; (B) material thickness and the method used to determine the thickness; (C) description of tank system piping (material, diameter); (D) description of any internal and external pumps; and (E) sketch or drawing of tank including dimensions. (3) documented age of the tank system, if available, otherwise, an estimate of the age based on owner or operator knowledge; (4) description and evaluation of the adequacy of any leak detection equipment; (5) description and evaluation of any corrosion protection equipment; (6) description and evaluation of any spill prevention or overfill equipment; (7) hazardous characteristics of the waste(s) that have been or will be handled; (8) description of any structural damage or inadequate construction or installation such as cracks, punctures, or damaged fittings. All discrepancies shall be documented in the assessment and remedied before the tank system is certified for use. (9) results of a leak test, internal inspection, or other tank system integrity examination including the type of integrity examination performed (i.e., ultrasonic, internal examination, volumetric tank test, pipeline pressure test). Tank system integrity or leak test requirements must be in compliance with all local requirements. Prior to conducting a tank system integrity test or leak test, contact local agency staff for local requirements. (10) estimated remaining service life of the tank system based on findings of subsections (g)(1) through (g)(9)• NOTE: Authority cited: Sections 25150, 25159, and 58012, Health and Safety Code. Reference: Sections 25159 and 25159.5, Health and Safety Code; 40 CFR Section 265.191.