Laserfiche WebLink
6A <br /> I. SITE CON TAC-TS <br /> Station Number: Former Exxon RS 7-1050 <br /> Station Address: 909 West Hammer Lane <br /> Stc_sckton,California <br /> Exxon's Project Manager: Ms.Debbie Hams <br /> Exxon Company,U.S.A. <br /> 1200 Smith Street, Room 31123 <br /> _ Houston,Texas 77002 <br /> (714)655-7755 <br /> Consultant to Exxon: EA Engineering,Science,and Technology <br /> 41 Lafayette Circle <br /> Lafayette, California 94549 <br /> (415)283-7077 <br /> EA Project Geologist: Alec Winters <br /> Site Location Map: Figure 1 <br /> { <br /> I ACTIVITIES,;UNE 1990 THROUGH SEPTEMBER 1990 <br /> 'rte Well Installation•28 Atigust.1990:- Three new monitb:ing wells-(MW6-MW <br /> 7,MW8) were in-. <br /> _ y± <br /> stalled adjacent to the three 66-foot-deep wells that had gone dry(MW3,MW4,MWS,-Figure 2): <br /> The borings for these wells were drilled according to ENS standard protocol as outlined in <br /> Appendix A. Soil samples were collected,described,and screened for the presence of organic <br /> vapors with an FID. Lithoiogie logs for these borings are included as Appendix B. <br /> € = Selected soil samples were submitted to Pace Laboratories for analysis for total petroleum <br /> ! hydrocarbons(TPH) as gasoline by DHA-modified EPA Method 8015 and for benzene, <br /> xylenes,and ethylbenzene(BTXE) by FPA Method 8020. The results of the laboratory analysis <br /> indicate that no concentrations of hydrocarbon constituents greater than method detection limits <br /> were found in any of the samples from the three borings (Table 1). Only one sample(MW6,50 <br /> y feet) contained organic vapors that were detected with the FID at the time of collection (see <br /> boring logs,Appendix B).. <br /> r :s <br /> -_- The borings-were completed as monitoring wells by installing 0.010-inch-slot PVC casing and a <br /> sand filter pack of#2/12 sand, At the recommendation of the San Joaquin Environmcntal Health <br /> . . <br /> District, thesaturated portion of the well casing was surged after placement of the sand pack and <br /> f. <br /> r . before installation of the Bentonite plug and surface seal: The wells were surged using a steel <br /> *T <br /> bailer on the winch of the drill rig for 10-15 minutes, and the depth to the top of she sand pack <br /> -„ p <br /> ' was,continuously monitored. The sand pack settled 0.9 feet in MW7,0.4 feet in MW8,and 0.0 <br /> 4, " feet in MW6 as a result of this surging. The height of the saturated filter pack was approximately . <br /> r y� 15 feet in all three wells. The total height of the sand filter pack was approximately 27 fee,in all <br /> three wells. Well completion diagrams are included as part of the boring logs in Appendix B. <br /> a t eaanlasa/nov/Ut t <br /> y <br /> T <br /> s. <br />