SU0012521 - Laserfiche WebLink

Home Browse Search

Pacific Gas and Electric Company" Attachment 1 —Gas Facilities There could be gas transmission pipelines in this area which would be considered critical facilities for PG&E and a high priority subsurface installation under California law.Care must be taken to ensure safety and accessibility. So, please ensure that if PG&E approves work near gas transmission pipelines it is done in adherence with the below stipulations. Additionally,the following link provides additional information regarding legal requirements under California excavation laws: http://usanorth811.org/wp-content/uploads/2017/05/CA-LAW-English.pdf 1. Standby Inspection:A PG&E Gas Transmission Standby Inspector must be present during any demolition or construction activity that comes within 10 feet of the gas pipeline.This includes all grading,trenching, substructure depth verifications(potholes), asphalt or concrete demolition/removal, removal of trees, signs, light poles, etc.This inspection can be coordinated through the Underground Service Alert(USA)service at 811.A minimum notice of 48 hours is required. Ensure the USA markings and notifications are maintained throughout the duration of your work. 2. Access:At any time, PG&E may need to access,excavate, and perform work on the gas pipeline.Any construction equipment, materials,or spoils may need to be removed upon notice. Any temporary construction fencing installed within PG&E's easement would also need to be capable of being removed at any time upon notice.Any plans to cut temporary slopes exceeding a 1:4 grade within 10 feet of a gas transmission pipeline need to be approved by PG&E Pipeline Services in writing PRIOR to performing the work. 3. Wheel Loads:To prevent damage to the buried gas pipeline,there are weight limits that must be enforced whenever any equipment gets within 10 feet of traversing the pipe. Ensure a list of the axle weights of all equipment being used is available for PG&E's Standby Inspector.To confirm the depth of cover,the pipeline may need to be potholed by hand in a few areas. Due to the complex variability of tracked equipment,vibratory compaction equipment,and cranes, PG&E must evaluate those items on a case-by-case basis prior to use over the gas pipeline(provide a list of any proposed equipment of this type noting model numbers and specific attachments). No equipment may be set up over the gas pipeline while operating. Ensure crane outriggers are at least 10 feet from the centerline of the gas pipeline.Transport trucks must not be parked over the gas pipeline while being loaded or unloaded. 4. Grading: PG&E requires a minimum of 36 inches of cover over gas pipelines(or existing grade if less)and a maximum of 7 feet of cover at all locations.The graded surface cannot exceed a cross slope of 1:4. 5. Excavating:Any digging within 2 feet of a gas pipeline must be dug by hand. Note that while the minimum clearance is only 12 inches,any excavation work within 24 inches of the edge of a pipeline must be done with hand tools.So to avoid having to dig a trench entirely with hand tools,the edge of the trench must be over 24 inches away. (Doing the math for a 24 inch wide trench being dug along a 36 inch pipeline,the centerline of the trench would need to be at least 54 inches[24/2+24+36/2=54]away,or be entirely dug by hand.) PG&E Gas and Electric Facilities Page 2