Laserfiche WebLink
Introduction Safety Symbols <br /> Safety Symbols <br /> The following safety symbols are used throughout this manual to alert you to important safety hazards and <br /> precautions. <br /> EXPLOSIVE FLAMMABLE <br /> Fuels and their vapors are extremely explosive if Fuels and their vapors are extremely flammable. <br /> ib ignited. `e <br /> � <br /> ELECTRICITY TURN POWER OFF <br /> High voltage exists in,and is supplied to,the Live power to a device creates a potential shock <br /> � device.A potential shock hazard exists. <br /> ` • hazard.Turn Off power to the device and associ- <br /> O ated accessories when servicing the unit. <br /> WARNING INJURY <br /> Heed the adjacent instructions to avoid equipment O Careless or improper handling of materials can <br /> damage or personal injury. result in bodily injury. <br /> • <br /> WEAR EYE PROTECTION GLOVES <br /> Wear eye protection when working with pressur- Wear gloves to protect hands from irritation or <br /> ized fuel lines or epoxy sealant to avoid possible fr injury. <br /> O eye injury. 11ii <br /> USE SAFETY BARRICADES READ ALL RELATED MANUALS <br /> Unauthorized people or vehicles in the work area are Knowledge of all related procedures before you <br /> dangerous.Always use safety cones or barricades, begin work is important. Read and understand all <br /> safety tape,and your vehicle to block the work area. �� manuals thoroughly.If you do not understand a <br /> procedure,ask someone who does. <br /> Before You Begin <br /> Prior to backfilling the tank top (i.e. covering the lines, UDC, etc.) the contractor is strongly advised to test all of <br /> the secondary containments for leaks, and to monitor the vacuum during the backfill process. Any leakage <br /> detected must be repaired to prevent future vacuum system alarms. <br /> CAUTION:Do not exceed equipment manufacturer's recommended vacuum levels! <br /> .® While it is common practice to use an independent vacuum source to provide the initial vacuum,you must ensure <br /> that pump lubricating oil and any other foreign substance is not introduced into the Secondary Containment <br /> Vacuum Sensor(SCVS)system.Failure to do so may damage the SCVS system and will void warranty. <br /> Hardware Requirements <br /> • TLS-350/35OR with version 24C or later software <br /> • For proper STP operation, an in-tank Mag Probe is required for TLS Systems without electronic Line Leak <br /> (PLLD or WPLLD). <br /> • At least one Smart Sensor with Pressure Sensor Module <br /> • Line leak (PLLD or WPLLD),Q[w/o line leak, a Pump Sense and a 4-Relay module is required for STP control <br /> 3 <br />