Laserfiche WebLink
Installation Installing Vac Sensor Housing Support Bracket <br /> Barbed tee Piece of tubing (typ.) <br /> Orient the barbed'---, Barbed elbow <br /> tee on this end so <br /> one of the ends <br /> is facing front <br /> vacsensors/fig 7 s.eps <br /> Figure 6. Attaching vacuum tubing between Vac Sensors(In this example there is no Tank monitoring) <br /> Installing Vac Sensor Housing Support Bracket <br /> Get the Vac Sensor housing support bracket and the curved tensioning clamp from the mounting kit. Hold the <br /> bracket against the STP riser. Place the curved clamp around the back of the riser and hook the four notches in the <br /> clamp over the four barbs in the top of the bracket (see Figure 7). Position the bracket so the top of bracket is at <br /> least 12 inches (304.8mm) above the containment sump floor and hand tighten the tension adjust knob on the <br /> back of the clamp until the assembly is secure. <br /> slots(4)-position over Tension adjust knob <br /> barbs on bracket <br /> Curved clamp <br /> Sump <br /> VAC Sensor <br /> housing support <br /> " bracket <br /> 12" (304.8mm) <br /> Minimum <br /> STP Riser <br /> Figure 7. Attaching Vac Sensor housing support bracket <br /> 9 <br />