Laserfiche WebLink
Installation Field Wiring Vac System Connections <br /> Epoxy sealant pak <br /> Vac Wire nut (3) <br /> Sensor ---------- <br /> White ; White (+) <br /> Black To Smart Sensor <br /> Red Black (-) Interface Module <br /> Red <br /> Black <br /> -------------- <br /> Vac Float or tank vacsensors/figlleps <br /> interstitial sensor <br /> Figure 14. Field wiring connections <br /> AC To sensor <br /> To console <br /> Make sure that <br /> the ends of cable <br /> sheathing are <br /> sub-merged in <br /> sealant Tie wrap <br /> ---Wire nuts <br /> Instructions: \ <br /> NOTE: When temperature is below 50°F (10°C), keep 4. Mix thoroughly to a uniform color by squeezing <br /> resin in a warm place prior to mixing (e.g., in an contents back and forth 25-30 times. <br /> inside pocket next to body). 5. Squeeze mixed, warm resin into one end of bag and <br /> 1. Open epoxy sealant package, and remove resin pakcutoff other end. <br /> 2. Holding resin pak as shown in A, bend pak along 6. Slowly insert wiring connections into sealing pack <br /> until they fit snugly against the opposite end as <br /> long length. shown in C. <br /> 3. As shown in B, firmly squeeze the RED SIDE of the 7. Twist open end of bag and use tie wrap to close it off <br /> resin, forcing it through the center seal and into and position the tie wrapped end up until the resin <br /> BLACK SIDE. jells. <br /> CAUTION:Epoxy sealant is irritating to eyes,respiratory system, <br /> O O and skin.Can cause allergic skin reaction.Contains:epoxy resin <br /> and Cycloaliphatic epoxycarboxylate. <br /> Precautions:Wear suitable protective clothing,gloves,eye,and <br /> face protection.Use only in well ventilated areas.Wash <br /> thoroughly before eating,drinking,or smoking. conso1es\epxy3warn.eps <br /> Figure 15. Epoxy sealing wiring connections <br /> 16 <br />