Laserfiche WebLink
Vac System Testing <br /> This section describes a sequence of procedures and tests necessary to complete the Vac Sensor installation: <br /> 1. ATM Pressure Sensor setup <br /> 2. Vac Sensor setup <br /> 3. Vacuum integrity test prior to filling tank* <br /> 4. Manual test* <br /> 5. Operability test <br /> *NOTE: Only one of these two tests is required to complete the installation. <br /> ATM Pressure Sensor Setup <br /> The ATM Pressure Sensor is factory installed in the Smart Sensor/ Press module and preassigned to channel 8. <br /> At least one Smart Sensor/ Press module,which contains the ATM Pressure Sensor, must be installed in the <br /> console.You must configure at least one ATM Pressure Sensor for use by the Vac Sensors or a Setup Data <br /> Warning will occur. NOTE: if more than one Smart Sensor/ Press module is installed, only one ATM Pressure <br /> Sensor needs to be configured. <br /> Look in console and note the slot position of the SmartSensor/Press module. Enter the Setup Mode and press <br /> the FUNCTION key until you see the message: <br /> SMARTSENSOR SETUP <br /> PRESS<STEP>TO CONTINUE <br /> Press STEP until you see the message: <br /> SS CONFIG-MODULE n <br /> SLOTx-XXXXXXXX <br /> Where x is the slot number containing the SmartSensor/Press module. Press the key to move the cursor to the <br /> last (8th) X. Press CHANGE and the message below should appear: <br /> SLOT x-X X X X X X X 8 <br /> PRESS<STEP>TO CONTINUE <br /> Press STEP: <br /> ENTER SMARTSENSOR LABEL <br /> s 8: <br /> NOTE: In the example above, the ATM P sensor position is 8 but it could bel 6, 32, or 40 depending on the <br /> SmartSensor's module number. <br /> Press CHANGE and enter a label: <br /> ENTER SMARTSENSOR LABEL <br /> s 8:(ATMP Sensor Label) <br /> 20 <br />