Laserfiche WebLink
OCT 23 2015 <br /> 3) Trimming and lamination areas <br /> You may need to trim down one or both of: Abrade walls 3" up and <br /> 1 down from the bottom <br /> > The existing tank sump reducer T of the Retrofit reducer <br /> or <br /> > The bottom edge of the Retrofit Reducer _1_ CENTERLINE <br /> v - -- - - - - - - - - - - - - - - <br /> 1 OF LAMINATION <br /> The goal is to have a smooth 6" of <br /> lamination area. You will be laminating �� p <br /> over the seam and over the tek screws. <br /> NOTE: DO NOT TRIM TOP EDGE OF <br /> DOUBLEWALL TANK SUMP REDUCER <br /> UNLESS AUTHORIZED BY MFG. c> Abrade the same <br /> amount in this <br /> In this image the sump reducer was scenario as well. <br /> trimmed down. Even though the bottom c> <br /> edge of the Retrofit Reducer is close to Ensure the <br /> the underside of the sump shoulder, this is transition <br /> J is as flat as <br /> fine. You can still laminate across this possible. <br /> radius. Proceed to step 4. <br /> 4) Leveling and Securing Retrofit Reducer <br /> With the interior walls of both reducers r <br /> properly abraded, secure the Retrofit Tek Screws <br /> reducer at the correct elevation (four) <br /> (Remember that clearance on page 3) �._.....#,_. <br /> by using standard tek screws about 1" up <br /> from the bottom edge. Install them all the - <br /> way flush at four locations, closer to the - - - - - - - - - - - - - - - - - - <br /> CENTERLINE <br /> centerline of lamination if possible.p l OF LAMINATION <br /> NOTE: DO NOT USE TEK SCREWS ON <br /> DOUBLEWALL TANK SUMPS. <br /> 5) Gap-filling & Gap-fill and <br /> transition with <br /> transitioning paste so your <br /> lamination path <br /> You may have a gap between the two will be as smooth <br /> reducers. It should not exceed 1/2" of gap. as possible <br /> Use provided Fiberglass paste to create <br /> a smooth transition over the tek screw <br /> heads and the reducer seam. <br /> 4 ii-RC-SNAPLOCK-RETROFIT-14B <br />