Laserfiche WebLink
OCT 2 8 2015 <br /> 7) Leveling and Securing Retrofit Reducer- . --,., <br /> Apply each "patch" horizontally, centered <br /> over the centerline of lamination (seam) <br /> where you applied the paste gap-fill and LAMINATE THE <br /> transition. You must cover the tek screws, INTERIOR SEAM, <br /> and overlap the lamination ends 3600 AROUND <br /> together by FOUR INCHES. Use the <br /> chamfer roller to roll out any air and <br /> flow-coat with remaining resin if you wish. <br /> DO NOT DISTURB ANYTHING <br /> WHILE LAMINATION IS CURING. <br /> CENTERLINE_ <br /> Allow for a full cure time. OF LAMINATION <br /> 8) Final Assembly <br /> After the lamination has cured, inspect for defects / flaws and patch as necessary. <br /> To install SNAP-LOCK cover: <br /> X) Remove protective wrapper from o-ring seal. It is pre-greased. Keep it clean of dirt / debris. <br /> 1) Unlock cams. <br /> 2) Step-to-seal. <br /> 3) Lock cams. <br /> If you are unfamiliar with this new cover, <br /> read all about it at: <br /> sbravo.com/snap d a <br /> a <br /> You can also see a video at- <br /> sbravo.com/videos a <br /> 6 ii-RC-SNAPLOCK-RETROFIT-14B <br />