INSTALL_2014 - Laserfiche WebLink

Home Browse Search

Arco AMPM #83333 550 West Valpico Road, Tracy SR0068583 Additionally, Each person installing or testing any component must hold a certificate of training from the manufacturer of that component. 5. The UST system must be compatible with the substance being stored, California Code of Regulations (CCR), Title 23, Section 2631.1. 6. All piping, fittings, sumps, and tanks must be certified by an independent testing organization and labeled as required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See Title 23 Chapter 16 Table B for complete list.) Pursuant to Underwriters Laboratories Inc (UL) listing requirements, only those products bearing the UL mark will be considered listed. ANY PART/PRODUCT NOT MARKED WITH THE UL LABEL OR ANOTHER LISTED TESTING ORGANIZATION WILL BE REJECTED. 7. All monitoring systems shall be listed in the CA State Water Resources Control Board (SWRCB) Local Guidance (LG) 113 letter. 8. All installation and testing shall be in compliance with manufacturer's instructions, CCR Title 23, Section 2635 and Section 2636. 9. All piping must slope to a containment sump with an audible/visual alarm. 10. UST sumps must be constructed "product tight" as defined by California Health and Safety Code (HSC) Section 25290.1. 11. All tank top openings that are connected to the primary space of the UST must have secondary containment, audible/visual alarm and be product tight or terminate at grade. 12. All secondary containment for the UST must be constructed per HSC Section 25290.1(c)(3). 13. The secondary containment system for the UST must be continuously monitored as required under HSC Section 25290.1 14. Overfill prevention for the UST shall satisfy CCR Section 2635(b)(2)(A) pursuant to the permit application. 15. All UST metal components in direct contact with the ground such as flexible connectors, swing joints, fittings, clamps, bands, and pumps shall have corrosion protection. 16. Any changes in the approved scope of work shall be submitted to the EHD for approval prior to commencing work. All new submittals supersede the previous ones. 17. A "Certification of Installation / Modification"form for each tank shall be submitted by the owner or the owners' agent [pursuant to CCR Section 2635(d)] before this install will be considered complete by the EHD. 18. An accurate and drawn to scale as-built plan must be submitted to the EHD prior to scheduling a final inspection. 19. No gasoline, diesel, or other hazardous material or waste can be released (intentionally or unintentionally) to the sewer/septic, storm water system, or any other waters of the state. If a release occurs it will be considered illegal hazardous waste disposal and will be subject to enforcement. 20. Passing Enhanced Leak Detection (ELD) results for the UST must be received by the EHD prior to depositing product into the UST. 21. The UST monitoring system and overfill prevention must be inspected and approved prior to depositing product into the UST. 22. Contact Thuy Tran, REHS at (209) 468-8257 for inspections. See the inspection checklist in the permit application for the required inspections. All appointments must be scheduled 48 hours in advance. 23. This permit expires at the end of the calendar year. A request for extension to this permit must be received by June 30, 2014. If you have any further questions, please contact me at (209)468-8257. Thank you, T uy Tran, Sr. REHS Senior Registered Environmental Health Specialist CC: Edgar Rizkalli sent via email diamondpetroleum1C@yahoo.com Page 2 of 2