Laserfiche WebLink
Bonded Sump Entry Fitting - Termination Style <br /> for Fuel Handling applications <br /> Installation and Application Instructions <br /> 1. Determine entry hole location and cut entry hole in sump wall using appropriate"C" dimensions in Table 1. <br /> 2. Using 40-60 grit fresh emery cloth or sand paper,sand the sump wall surfaces, inside and outside,to the diameter of the <br /> alignment rings.All glazed surface must be removed.Once finished sanding, remove all dust from the sanded area. <br /> 3. Place two alignment rings on sump entry fitting and insert through sump wall from outside the sump. Locate the 1/4 inch <br /> threaded outlet to the desired angular location. <br /> If this fitting is used in an Open (Drainage) System, locate the 1/4 inch threaded outlet in the 6 o'clock position. <br /> Leave 1/4 inch plastic threaded outlet protector in place until 1/4 inch fitting installation. <br /> 4. Dry fit primary pipe and rotate the two rings until the desired angle is reached. Maximum allowable offset is 5°. <br /> Make alignment marks on the rings,the sump entry fitting,and the sump wall. Be sure to mark the rings so they can be <br /> placed in the same location and sequence during bonding. <br /> SUMP WALL--\ <br /> OUTSIDE <br /> SUMP <br /> INSIDE <br /> SUMP A <br /> B <br /> - - T - - <br /> C <br /> ®, n HOLE Fitting — <br /> DIA <br /> Dimensions <br /> Size A B C <br /> Inch Inch Inch Inch <br /> 3 x 2 6.88 4.00 4.00ENTRY TERMINATION <br /> RETAINING ALIGNMENT FITTING BODY <br /> 4 x 3 6.88 4.00 5.00 RING RINGS <br /> NOTE:These fittings can only be bonded toR-," E <br /> r. <br /> flat walled,fiberglass sumps.DO NOT install <br /> on thermoplastic or round sumps. , <br /> JAN 08 2015 <br /> ENVIRONM E I AI <br /> 0 Fiber Glass Systems <br />