COMPLIANCE INFO_2000 - 2011 - Laserfiche WebLink

Home Browse Search

Testing Company Name: AFFORDA-TEST Phone No. (209)744-0113 Testing Company Address: 416 2" STREET GALT,CA 95632 Date of Testing/Servicing: 7/28/11 Monitoring System Certification Page 1 of 2/21/07 D. Results of Testing/Servicing Software Version Installed: 328.03 Complete the following checklist: ® Yes ❑ No` Is the audible alarm operational? ® Yes ❑ No` Is the visual alarm operational? ® Yes ❑ No' Were all sensors visually inspected,functionally tested,and confirmed operational? ® Yes ❑ No` Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? ® N/A ® Yes ❑ No' For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, ❑ N/A fails to operate, or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) ® SumplTrench Sensors; ®Dispenser Containment Sensors. Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ®Yes; ❑No. ❑ Yes ❑ No` For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.,no mechanical overfill prevention valve is ® N/A installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? % ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E,below. []Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑Product; ❑Water. If yes,describe causes in Section E,below. ® Yes ❑ No` Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable ® Yes ❑ No` I Is all monitoring equipment operational per manufacturers specifications? 'In Section E below,describe how and when these deficiencies were or will be corrected. E. Comments: Found 2 raised sump sensors repositioned in correcto position.