INSTALL_2000 - Laserfiche WebLink

Home Browse Search

® I. joint cleaning smoke or use near an open the washed surface is com- Use sufficient joint cleaner flame. Use with adequate venti- pletely dry, follow steps a trichloroethane) and lation. Refer to the warning and b above. clean paper towels provided in label on each container. 2. Adhesive mixing adhesive kits (note: DS-7054 If more joint cleaner is needed, Thoroughly mix the adhesive. and DS-8055 bag kits do not use 1,1,1 trichloroethane. If Complete information and safety come with joint cleaner). Use 1,1,1 trichloroethane is not precautions are packaged with only enough cleaner to wet out available, acetone or methyl each adhesive kit. the paper towels, and never ethyl ketone is acceptable. a. When the weather is cool or pour the cleaner directly into or WARNING: ACETONE AND the adhesive has been stored onto the joint (See Figure 1.6.5). ZIN METHYL ETHYL KETONE in a cool environment (60° Cleaner containers may be ARE EXTREMELY FLAMMABLE. F/16° C or below),prewarm • under pressure.Use caution When using these cleaners, do the adhesive kits. Do not when removing inner seals, not smoke or use near an open heat above 80° .) (27° especially in warm weather. flame (such as near the pilot (See Figure hardeners ) a some Use eye protection. 1,1,1 tri- light or burner of a gas cases, hardeners may crys- chloroethane is not classified as appliance). Failure to follow tallize. If this occurs, refer to flammable; however, concen- this warning can result in the installation instructions trated vapors can be ignited. serious personal injury or provided in each kit. When using this cleaner,do not death. Never use alcohols, b. Empty all of the contents of gasoline, turpentine, or diesel the hardener bottle into the fuel to clean joints. can of base adhesive (See a. Clean all of the bonding Figure 1.6.7). surfaces with joint cleaner c. Mix all of the adhesive with to remove oil, grease, mud, all of the hardener. NEVER fingerprints, etc. SPLIT A KIT. Do not spill S hardener during the mixing b. After cleaning, do not touch process. Cut through the the bonding surfaces or allow adhesive with the edge of them to be contaminated. the mixing stick to assist in Make sure that the cleaner mixing the two components. has evaporated from the d. Mix until the adhesive has a bonding surfaces before uniform colorand a consist- applying adhesive. ent flow off the mixing stick c. When bonding surfaces are (See Figure 1.6.8). Wipe heavily soiled, mild soap down the sides,bottom,and and water followed by a under the rim of the can clean-water rinse may be with the mixing stick to Figure 1.6.5 required for cleaning. After assure complete mixture. C F Figure 1.6.6 Figure 1.6.7 Figure 1.6.8 11