INSTALL_2000 - Laserfiche WebLink

Home Browse Search

PART TWO Installation Instructions for Secondary Containment Piping INTRODUCTION SMITH Useful sections of Part One: ble pad with 40 grit or less - Before beginning any instal- Section 1 - Storage and Handling disc), or lation, it is important that all Section 2 - Layout and Preparation b. hand file (coarse) crew members read and be Section 3 -Tool and Equipment List 2. Fine-tooth circular hole saw familiar with the installation Note: For installation of bolts,nuts, with pilot drill procedures described in this and washers, use one of the 3. Hose clamps or Band-It(1)band- manual. following: ing tool large enough to secure The secondary containment 1 . 3/8-inch variable impact saddles to pipe. (If banding is piping system is designed for use wrench with 7/16-inch deep used, the Band-It banding tool with RED THREAD II and RED socket, and 7/16-inch wrench is preferred because this tool THREAD IIA product pipe. The does not leave slack in the band secondary containment system 2. 1/4-inch variable speed drill when the tool is removed.Two consists of the next larger size pipe motor with 7/16-inch socket Band-It tools are recommended and special two-piece fittings. and 7/16-inch wrench so that the saddle can be pulled Many of the procedures used for 3. two 7/16-inch wrenches down uniformly. Use 3/4-inch installing product pipe and fittings (19 mm) banding. are also used for installing secon- For installing saddles, the follow- dary containment pipe and fittings. ing equipment is recommended: Section 5 - Cutting and Tapering Refer to Part One for installation 1. Sanding equipment (cutting) '( instructions for product pipe and Section 6 - Installation fittings and to Manual No. F6600 for a. power sander with rough (piping layout and trench design; tapering tool operating instructions. surface sanding disc (flexi- adhesive mixing and curing) SECTION 1 SECONDARY CONTAINMENT PIPING SYSTEM COMPONENTS 2.1.1 Secondary containment pipe elbows, couplings, nipples, termi- heat cured. For petroleum pro- Smith Fiberglass Products secon- nation concentric reducers (with ducts, use DS-7000 series adhe- dary containment piping sizes are or without 3/4" NPT threaded sives. When joining secondary as follows: outlet) and saddles (belled or with containment pipe-to-fittings and NPT threaded outlets). fittings-to-fittings, fiberglass filler Containment For Product 2.1 .3 Adhesive for secondary must be added to the adhesive to Pipe Size Pipe Size containment piping ensure optimum performance of 3" 2" this type of bonded joint. Filler 4„ 3„ For alcohols and alcohol-gasoline must be ordered from Smith 6„(2) 4„ mixtures, use only DS-8000 series Fiberglass Products. Due to the adhesives manufactured by Smith quantity of adhesive required for Fiberglass Products for installing joining secondary containment 2.1.2 Secondary containment fittings secondary containment piping fittings, it is recommended that Available secondary containment systems. All bonds made with only DS-7014 or DS-8014 and fittings are tees, 90° elbows, 45° DS-8000 series adhesives must be DS-7069 or DS-8069 kits be used. (1)Band-It banding tool available from Band-It Idex,Inc.,P.O.Box 16307, (2)NOTE:6”(152 mm)secondary containment pipe is not LIL Listed. 4799 Dahlia Street,Denver,Colorado 80216,(303)320-4555. 23