Laserfiche WebLink
f - <br /> SECTION 4 <br /> TERMINATION CONNECTIONS <br /> 2.4.1 Termination at the storage Termination of the secondary or sleeve couplings may be used <br /> tank containment piping system at the (See Table 2.4.1). Non-machined <br /> Termination of the secondary con- dispenser is accomplished using a surfaces must be sanded to fit the <br /> tainment piping system at the stor- termination concentric reducer with secondary containment fittings <br /> age tank is accomplished using a or without the 3/4" NPT threaded (See Figure 2.4.3). <br /> dispenser <br /> outlet (See Figure 2.4.2). To facili- Note:Termination at the dis <br /> termination concentric reducer p <br /> with 3/4" female NPT threaded tate ease of terminating, special can also be accomplished with a <br /> outlet (See Figure 2.4.1). The 3/4" bell x male adapters for secondary gasoline resistant boot, clamped <br /> threaded outlet allows easy access containment (which have been and bonded in place.The gasoline <br /> for pressure testing of the secon- machined to fit the secondary con- resistant boots, which contain the <br /> dary containment piping system tainment fittings) are available for flexible connectors, are not supp- <br /> and may also be used as an access use with secondary containment lied by Smith Fiberglass Products. <br /> for a leak detection probe. termination fittings.If machined bell Contact your Smith Fiberglass <br /> x male adapters are not available, Products distributor for product <br /> 2.4.2 Termination at the dispenser standard male threaded adapters information. <br /> Fiberglass Dispenser <br /> Threaded Adapter <br /> (� �> (Bell x Male) <br /> Impact Valve <br /> Fiberglass <br /> Threaded Adapter <br /> (Bell x Male) <br /> O O <br /> O <br /> :�_ <br /> O 3/d'NPT <br /> Tank o 0 <br /> 0 <br /> Flexible <br /> O Connector <br /> Figure 2.4.1 Figure 2.4.2 <br /> Sand the O.D. If there is a <br /> of adapter or gap between <br /> coupling so that the reducer <br /> the reducer + halves when <br /> halves fit to- assembled by <br /> gether when I hand, more <br /> assembled by sanding is <br /> hand. required. <br /> Figure 2.4.3 <br /> 27 <br />