SU0005344 ENG DES PLN - Laserfiche WebLink

Home Browse Search

The XIGATAI Concept and Operation Manual 'I-Ix-FLOW Start-up Procedure To prevent dehydration and growth of bacteria, the membrane elements are saturated with a water/glycerine/sodium bisulfite solution (79:20:1 [wUwt/wt%]). This solution should be flushed out before use, according the following flush procedure: • Connect clean water(preferably drinking water quality or better)to feed. • Open feed and concentrate valves, and flush during 5 minutes without permeate flow. • Reduce feed flow and open permeate valve. Start filtration and adjust permeate flow to 50 I/m2h. Let the system filtrate for 15 minutes. • Perform a backwash for 30 seconds. Adjust the backwash flow to 50 I/mzh. • Start filtration , adjust permeate flow to 80 I/mzh. and let the system filtrate for 15 minutes. • Perform a backwash for 30 seconds. Adjust the backwash flow to 80 I/mzh. • Start filtration, adjust permeate flow to 100 I/mzh. and let the system filtrate for 15 minutes. • Perform a backwash for 30 seconds. Adjust the backwash flow to 100 I/m2h. • Start filtration and adjust permeate flow to 100 I/m2h. let the system filtrate for 15 minutes. • Perform a backwash for 30 seconds. Adjust the backwash flow to 200 I/mzh. • Start filtration, adjust permeate flow to 100 I/mzh. Let the system filtrate for 15 minutes. • Perform a chemical enhanced backwash (CEB) with 100 ppm active chlorine (NaOCI). 30 seconds backwash with a flux of 200 I/mzh 30 seconds backwash with a flux of 125 I/mzh plus NaOCI dosing 5 minutes soaking 30 seconds backwash with a flux of 200 I/mzh • Start filtration, adjust permeate flow to design flux. Let the system filtrate for 15 minutes. • Perform a Backwash for 30 seconds. Adjust the backwash flow to design flux. Note: Always keep TMP during filtration <0.5 bar. In total a volume of 150 I. of clean water per mZ membrane area is needed to perform this flush procedure. The system is now ready for use CAPF-XIGA-0143