Laserfiche WebLink
00 prodnclti c..of xurruwenlo Safety Data Sheet (SDS) <br /> ABCO Products of Sacramento <br /> Alumatte Etch <br /> SDS Number: 101 Revision Date: 12/26/2014 <br /> Page 5 of 9 <br /> Handle with care and avoid spillage on the floor. <br /> Keep material out of reach of children. <br /> Keep material away from incompatible materials. <br /> Do not use corrosive-sensitive materials for handling product. <br /> Wash thoroughly after handling. <br /> Ensure adequate ventilation. <br /> Storage Requirements: Keep away from heat, sparks and flames. <br /> Do not store in direct sunlight. <br /> Store away from strong acids, strong reducing agents, strong oxidizing agents, organic <br /> materials,water, chlorinated solvents, reactive metals(Zinc&Aluminum)and their alloys <br /> (Brass),Alkali metals (Lithium, Sodium, Potassium,etc.),Tin&Tin oxides, Lead, <br /> Phosphorous&Phosphorous Pentoxide, Nitro compounds(Nitromethane,etc.),Azides, <br /> Anhydrides and Halogens. <br /> EXPOSURE CONTROLS/PERSONAL PROTECTION <br /> Engineering Controls: All ventilation should be designed in accordance with OSHA standard (29 CFR 1910.94). Use <br /> local exhaust at filling zones and where leakage and dust formation is probable. Use <br /> mechanical (general)ventilation for storage areas. Use appropriate ventilation as required to <br /> keep Exposure Limits in Air below TLV&PEL limits. <br /> Personal Protective Equip: Eye/face protection: <br /> When using material use safety glasses,gloves and apron according to HMIS PP, C. All <br /> safely equipment should be tested and approved under appropriate government standards <br /> such as NIOSH(US)or EN 166(EU). <br /> Skin protection: <br /> Handle with gloves made from Neoprene, Nitrile or Buma rubber. Gloves must be inspected <br /> prior to use. Use proper glove removal technique(without touching glove's outer surface) to <br /> avoid skin contact. Dispose of contaminated gloves according to applicable laws and <br /> laboratory practices. <br /> Body Protection: <br /> Chemically resistant gloves,apron and safely glasses are recommended. Type of protective <br /> equipment should be selected based on concentration amount and conditions of use of this <br /> material. <br /> Respiratory protection: <br /> Full-face dust/vapor respirator may be required as backup to engineering controls when <br /> proper engineering controls are not in place to keep TLV and PEL limits below defined <br /> thresholds. <br /> Control of environmental exposure: <br /> Prevent leakage or spillage if safe to do so. Do not let material enter drains. <br /> Components with workplace control parameters: <br /> Component(s): Sodium Hydroxide,solid <br /> CAS No(s): 1310-73-2 <br /> USA OSHA Table Z-1 Limits for Air Contaminants(C): 2 mg/m' <br /> USA OSHA Occupational Exposure Limits Table Z-1 Limits for Air Contaminant(TWA): 2 mg/m' <br /> USAACGIH (C/TLV): 2 mg/m' <br /> USA ACGIH (CEIL/TLV): 2 mg/m' <br /> USA NIOSH Recommended Exposure Limits(C): 2 mg/m' <br />