COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

B31W4451 CANCER INFORMATION For complete discussion of toxicology data refer to Section 11. SECTION 4-FIRST AID MEASURES EYES: Flush eyes with largeamounls ofwaterfor 15 minutes.Gel medical attention. SKIN: Wash affected area thoroughly wit soap and water. Remove contaminated clothing and launder before re-use. INHALATION: If affected,remove from exposure.Restore threat ing.Keep warm and quiet. INGESTION: Do not induce vomiting.Gel medical attention immediatly. SECTION 5-FIREFIGHTING MEASURES FLASHPOINT LEL UEL FLAMMABILITY CLASSIFICATION Not Applicable Not Not Not Applicable Applicable Applicable EXTINGUISHING MEDIA Carbon Dioxide,Ory Chemical,Alcohol Foam UNUSUAL FIRE AND EXPLOSK/N HAZARDS Closed containers may explode(due to the build-up of pressure)when exposed to extreme heal. During emergency conditions overexposure to decomposition products may cause a health hazard.Symptoms may not be immediately apparent.Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full prolective equipment including selfcontainetl breathing apparatus should be used. Water spray may be ineffective.If water is used,fog n.Ls are preferable.Water may be used to cool closed containers to prevent pressure build-up and possible autoignil'ron or explosion when exposetl to extreme heaL SECTION 6-ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED Remove all sources of ignition.Ventilate to area. Remove with inert absorbent. SECTION 7-HANDLING AND STORAGE STORAGE CATEGORY Not Applicable PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Keep container closed when not in use.Transfer only to approved containers with wmpste and appropriate labeling.Do not Wks internally. Keep out of to reach of children. SECTION 8-EXPOSURE CONTROLSIPERSONAL PROTECTION PRECAUTIONS TO BE TAKEN IN USE Use only with adeq unto ventilation. Avoitl contact with skin and eyes.Avoid breathing vapor and spray mist. Wash hands after using. This waling may contain materials classified as nuisance particulates(listed"as Oust"in Section 2)which may be present at hazardous levels only during sanding or abrading of the dried film.If no specific dust are listed in Section 2,to applicable limits for nuisance dust are ACGIH TLV 10 mg/m3(total dust),3 mg/m3(respirable fraction),OSHA PEL 15 mg/m3(total dust),5 mg/m3(respirable fraction). Removal of old paint by sanding,scraping or other means may generale dust or fumes that contain load.Exposure to katl dust or fumes may cause brain damage or other adverse health effects,especially in children or pregnant women.Controlling exposure to lead or other hazardous substances requires to use of proper prolective Nu ipmenl,such as a properly fitted respirator(NIOSH approved)and proper contain menl and cleanup.For more information,call the National Lead Information Center at 1-30"24-LEAD(in US)or contact your Iocel health authority. VENTILATION Local exhaust preferable.General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure limits.Refer to OSHA Standards 1910.94,1910.107,1910.108. RESPIRATORY PROTECTION If personal exposure cannot be conlmlletl below applicable limits by ventilation,wear a propery fitted organic vapcnparticulale respirator approved by NIOSH/MSHA for protection against materials in Section 2. When sanding or abrading to dried film,wear a dust mist respirator approved by NIOSH/MSHA for dust wh loh may be generated from this product,underlying paint,or to abrasive. PROTECTIVE GLOVES Wear gloves which are recommended by glove supplier for protection against materials in Section 2. EYE PROTECTION Wear safety spectcss with unperforated sideshields. page 2 of 4