WORK PLANS_FILE 1 - Laserfiche WebLink

Home Browse Search

U t� (i.e., the north end of the pump island). ATCff�oses to advance two (2)soil borings (designated SB-4 and SB-5) to an approximate depth of ap,foximately 15 feet bgs. One soil sample will be collected from each of the two proposed borings at th .capillary fringe, and one groundwater sample will be collected from each boring at approximately 15 eet bgs. Borings SB-4 and SB=5 will then be advanced to 40 feet-.Sam bgs, and groundwater samples will be collected from the bottoms of those borings using Hydropunch bvvv�tn/� techniques. One(1)additional boring(SB-6)will be continuously cored to a depth of approximately 40 feet bgs; a soil sample will be collected at the capillary fringe from this boring. Depth discrete groundwater samples will also be collected from the shallow zone(from approximately 15 feet bgs)and the deep zone (from approximately 40 feet bgs) at boring SB-6. The anticipated scope of work is as follows. SCOPE OF WORK Task 1 Pre-field Activities/HASP i This task includes all the activities related to pre-mobilization, permits, site clearance and site specific E Health and Safety Plan (HASP) preparation. The drilling permit will be obtained from SJCEHD. A work plan is also required for submittal with the drilling permit application. The borehole locations will be marked with white paint and ,Underground Service Alert (USA) will be notified at least 48 hours prior to initiating drilling activities to allow time for utility.companies to identify underground lines, pipes, or cables that may be affected by the drilling activities. A.private utility locator will also be retained to ensure that the i proposed locations do not conflict with underground utility locations. A HASP will be prepared for the I subject site investigation based on requirements of Title 29 of the Code of Federal Regulations (CFR) Section 1920.1200), the California General Industry Safety Order(GISO) and Title 8, California Code of Regulations (CCR) Section 5192: A copy of the HASP will be on-site during the course of the field activities. Task 2 Drilling/Soil and Groundwater Sampling/Sample Analysis ATC will utilize hand-auger techniques to clear the proposed boring locations to approximately 5 feet bgs. All drilling and sampling activities will be performed consistent with ATC's standard operating procedures (Attachment if )` o+' The locations of the proposed borings are illustrated on Figure 1,Proposed Boring Location Map.The soil i borings will be drilled using a track-mounted, direct push (Geoproobbe)drilling rig. Drilling will be conducted by a California C57-licensed drilling company. :An ATC field scientist, under the responsible charge of a California registered professional engineer or geologist,will log the borings and collect soil samples. ATC proposes to advance three soil borings (S!34,'S!3-5 and SB-6) at the locations presented in Figure 1. During drilling of borings B-4 and B-5, an approximately 1.5-inch diameter borehole will be advanced and logger ed to an approximate.,depth of 15 feet bgs (approximately 2�to 3_feet below first encountered groundwater). Soil samples will be collected just above the water table(i.e., at approximately 10 feet bgs) or where elevated PID readings indicate the presence of impact. A shallow zone groundwater sample will V � Additional Investigation Workplan Quik Stop No.132,Stockton,CA May 18,2009 t 3