Laserfiche WebLink
Aug 29 13 11 : 55a Elite 'V Contactors 12094616342 p. 12 <br /> STEP 6 ( COMPLETE ❑ <br /> 16 J <br /> BEAD ADHESIVE <br /> BEAD ADHESIVE ON <br /> BOTH CRITICAL SEAMS <br /> j If <br /> I <br /> I <br /> I, <br /> PRESS FITTING <br /> woo <br /> HALVES FIRMLY <br /> AGAINST THE WALL �~ <br /> SECURE THE FITTING <br /> HALVES TOGETHER WITH <br /> PROVIDED PIPE CLAMP <br /> �d <br /> Adhesive should ooze from every seam and joint while puffs: Ing the fitting halves <br /> together against the pipe and wall. Clean the face of the filti 'ig with acetone or <br /> equivalent and remove excess adhesive. You want the fittiii• i clean enough to <br /> remove the pipe clamp after the fitting cures. <br /> Use provided pipe clamp to secure the fitting halves to ea,i:l other. More adhesive <br /> may ooze from the split seams as you tighten, re-clean as r „cessary. <br /> CURE IT <br /> After a full cure, remove the pipe clamp holding the two fitti ig halves together. If it is <br /> too difficult to remove and appears to be bonded in place, c a not force it off. <br /> 13 -F-Series-Retrofit-SD-AB-1313 <br />