COMPLIANCE INFO_2005 - 2012 - Laserfiche WebLink

Home Browse Search

" - 9 - Module via a conduit dedicated to TLS Console low-voltage sensors. Figure 2113-7 shows an ISD Vapor Pressure Sensor illustration. Figures 2113-10 and 26-11 show the dispenser installation configuration. Figure 26-12 shows the vapor vent stack installation configuration. Dispenser Interface Module (DIM) Existing Dispenser Interface Modules or DIM communication cards are used to interface to the dispenser Point Of Sale (POS) or controller system to gather fuel transaction data. The ISD Operability Test Procedure provided in Exhibit 10 and Exhibit 17 and in Section 4 of the Veeder- Root ISD Install, Setup and Operation Manual for VST ECS Membrane Processors can be used to verify the proper selection and setup of the Dispenser Interface Module. See Figure 26-8 for a typical Dispenser Interface Module Illustration. Tank Inventory Probe Sensor Existing Tank Inventory Probe sensors (one per tank) are used to measure the amount of vapor space in the Underground Storage Tanks (USTs). The ISD Operability Test Procedure can be used to verify the proper selection and setup of the Tank Inventory Probes. See Figure 2113-9 for a typical Tank Inventory Probe Sensor. Shutdown Control The TLS Console must be wired per the Veeder-Root ISD Install, Setup and Operation Manual 577013-937 Rev. D of the ARB Approved Installation, Operation and Maintenance Manual for the VST Phase Il EVR System Including the Veeder-Roof ISD System such that it shall automatically prohibit the dispensing of individual dispensers or through shutdown of all the gasoline turbine pumps during a CP-201 ISD failure alarm. It shall also automatically prohibit the dispensing of all dispensers during a TLS Console ISD system power loss. TLS Console Modules The ISD Operability Test Procedure in Exhibit 10 and Exhibit 17 and in section 12 of ARB Approved IOM Manual(Section 4 of the Veeder-Root ISD Install, Setup, and Operation Manual for VST ECS Membrane Processors)shall be used to verify the proper selection and setup of the TLS Console Modules. Training Program All Veeder-Root contractors must successfully complete the applicable Veeder-Root training program before they can install, startup, and service TLS Console equipment. Contractors must have up-to-date Level 1 certification to install the TLS Console ISD system. Contractors must have an up-to-date Level 2, 3 or 4 certification and the ISD certification to startup and service the ISD system. The schedule, fee and registration information for the Authorized Service Contractor (ASC) training program can be found at http://www.veeder.com. To confirm TLS or ISD training a regulator should send an email to technicaltraining(a-)gilbarco.com with the name (and company) of the ASC to obtain verification of the ASC TLS/ISD training status or call 800-997-7725 and press "'' to get to the Veeder-Root menu and "*" again to speak to a representative. VST Phase 11 EVR System Including Veeder-Root ISD, Exhibit 2 - VR-204-H